bing tracking image

Pollak Wiring - Wiring Adapters - PK12716 Review

content loading

Customers compare PK12716 to these similar products

Products Featured in this Video

Review of Pollak Wiring PK12716

Today we're going to be reviewing part number PK12716. This is the Pollak 7-Pole to 4-Pole Connector Adapter. This adapter is going to promote quick and easy conversion of your 7-pole plug to a 4-pole flat connector. You can see here that this is going to connect to the 7-pole adapter. This only got 4 pins so it's just going to send through the functions of the 4-way flat that it needs to. Then on this side, you're going to be able to undo the dust cap.

It's going to expose your 4-way flat and then you can connect your 4-way flat connector to this connection here and then have full access to the connection in the towing application that you need. It's going to allow one vehicle to tow, either campers or boat trailers, without electrical brakes. This is going to connect the ground, left turn, right turn and stop circuits. Again, it's got that nice tethered cap for protection from sand, dirt and moisture. It's all about protecting those connection point. That cap is attached to the socket, that way you don't have to worry about misplacing it or losing it. This unit is made from a non-corrosive nylon shell and insert.

It's going to be highly resistant to rust and corrosion, providing many years of use. It is small enough, that way you can leave it connected if you're just . For short term reasons or you can fully disconnect it, put this in the glove box or the center console in your vehicle or a storage compartment of your RV. You always have it handy, ready to be pulled out and use it anytime. When it comes to the application, this is designed to be used with vehicles with 7-pole connectors. Real quick, I just want to go over few of the measurements of you.

The overall length of the unit measuring from end to end is going to be about 3-3/4 of an inch and the other measurement is basically self explanatory. It is designed to fit into the 7-way connector. I just want to give you an idea of how much length you're going to have sticking out once it is connected. It's got the nice little key lock up here, that way you can make sure that it slides into the appropriate groove on the 7-way socket. Just line that up, center at the 12 o'clock position, push it in until it snaps into place and then that lid is going to snap over the end here, which is going to hold the connector firmly in place, making sure that nothing comes in between the connection points on the socket and the connector. It's got the nice pull tabs right here. That way you can get easy grip on it and easily disconnect the unit from the connection.

That's going to do it for today's review of part number PK12716. This is the Pollak 7-Pole to 4-Pole Connector Adapter. .

Info for this part was:

Employee Joe V
Installed by:
Joe V
Employee Randy B
Installed by:
Randy B
Employee Andrew K
Video Edited:
Andrew K
Employee Jacob T
Video Edited:
Jacob T
Employee Nicholas E
Test Fit:
Nicholas E
Employee Alan C
Video by:
Alan C
Employee Zach D
Video by:
Zach D

At we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.