Optronics Trailer Lights A47PB Review

content loading



Customers compare A47PB to these similar products




Products Featured in this Video



Review of Optronics Accessories and Parts A47PB


Today we're going to take a look at the right angle three wire pigtail for the optronics tail lights with the 10 inch leads. Now this pigtail with the three prong plug will allow you to wire your optronics light to your trailer. It is designed specifically for use with the optronics stop tail turn light and parking turn lights and the warning lights. It is a right angle design. You can see here the design of the plug will allow the wiring to come out, run down from the light rather than straight out of the back. You notice it's a male pin, three prong PL three molded plastic plug, which will connect to the back of the trailer light.

Three wire pigtail, you notice the white wire does have the eyelet on it. It's a number 10 ring terminal. That's your ground wire. The black wire would be for your tail light and the red wire's for your turn signal and, again, the length of the leads on these are 10 inches so what I'm gonna do now is I happen to pull a LED optronics light with the three pronged plug so you can see on the back here, if you just match up your three pronged plug and go ahead and push it in, plug it into place, you can see that it lets your wires come out and go 90 degrees down instead of straight back, which could interfere with something on your trailer but that should do it for the review on the right angle three wire pigtail for the optronics tail lights with the 10 inch leads.


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Jeff D
Installed by:
Andrew S
Video Edited:
Chad S
Video Edited:
Chris R

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.