Review of Mount-n-Lock RV and Camper Hitch - Bumper Mount Hitch - MNT72VR Video

Hey Danny, what you would want is the ShakeStopper Heavy Duty 2 inch hitch part #MNT72VR which has a 400 lb tongue weight capacity and was designed with heavier bike racks in mind. The hitch you mentioned only has a 100 lb capacity so it would not be…

Hey Chris, thanks for reaching out! The Mount-n-Lock SafetyStruts Standard RV Bumper Support Brackets #MO22FR can support up to 400 lbs of cargo and would allow you to use the full 350 lb tongue weight rating of a hitch receiver like the etrailer RV…

Hi George, Most OEM bumpers are typically 4" x 4" so you could just go with the the #MNT72VR instead and add on the Mount-n-Lock SafetyStruts Universal RV Bumper Support Brackets #MO34VR to increase the capacity of the OEM bumper to 400lbs.…

I do say those welds are bad and it appears the bumper is simply welded onto the back plate of the trailer rather than the frame. I recommend removing the entire bumper for the Mount-n-Lock Heavy-Haul'r Replacement RV Bumper #MNT43VR which you…

The Swagman Replacement Cross Rail, part #SC64663-CR measures 27-1/2 inches long. According to my contact at Swagman, this rail will only work on the Swagman XC rack. If you would care to provide me with the model number of the rack you have, I would…

We have exactly what you need for a bike rack as well as a hitch, and since you have a 4" square bumper, you can use a bumper-mounted hitch. This means you don't have to use a hitch extender, and can put the bumper-mounted hitch along the…

Many RV bumper manufacturers construct their product with a plastic cap or a hinged door instead of endcap, allowing bumper to be used for storage; apparently you have this type. Open that end piece to examine if the seam has spot welds (short welds…

I would be happy to help! The only difference between the Mount-n-Lock Safety Struts #MO34VR and #MO22FR you were looking at is the hardware used to attach them. The #MO34VR uses nuts and bolts where the #MO22FR uses self tapping screws. Since both…

It's possible to use two sets of the Mount-n-Lock SafetyStruts Standard RV Bumper Support Brackets part #MO22FR but you might need to alter the hardware or instructions slightly. That said, it's not needed nor would it produce a higher…

I do have a bike racks that you can potentially use with the Stromberg Carlson Bike Bunk #CC-275. Just for reference, the Thule T2 Pro XTR #TH83JV that you currently use measures 41-1/2" from the center of the hitch pin hole to the farthest edge…

I do have an option for you but there isn't a spare tire holder designed to be used with the 24x60 etrailer Cargo Carrier for RV Bumper part #e99049. That said, you might be able to use something like the CE Smith Spare Tire Carrier for Trailers…

The 24x84 etrailer Cargo Carrier for RV Bumper part #e96ZR can hold a spare tire but there isn't any sort of specific mount for this. The photo attached below is a custom job from a neighbor and I'm not totally sure what they used to create…