bing tracking image

Review of Gen-Y Hitch Hitch Pins and Clips - Standard Hitch Pin - 325-GH-099

content loading

Customers compare 325-GH-099 to these similar products




Products Featured in this Video



Gen-Y Hitch Hitch Pins and Clips - Standard Hitch Pin - 325-GH-099 Review


Hello, everybody. This is Jeff at etrailer.com. Today, we're gonna take a look at the Gen-Y Hitch 5/8 inch diameter stainless steel pin and clip for a 2 1/2 inch and three inch hitches. Now, this hitch pin will secure your ball mount or other hitch mounted accessory in your trailer hitch receiver. This one does include the nice twist clip design, which inserts into the end of the pin right here in this hole to hold your pin in place. Now, I do wanna go over this twist clip design.

It's a little different than your standard clip that you'll see on hitch pins. Your standard clip, I happen to pull one, is your straight, push-on clip. And sometimes those can be difficult to push it on and sometimes hard to pull off. This twist clip makes it so much easier. What's nice about it is when you go to install it, you just put it on like this, push it.

And when you push it, it'll twist into place and lock into place. You're ready to go. And very easy to remove. All you have to do is twist this and it comes right out. So, installing this clip is a lot simpler using this new twist clip design.

Now, this is a sturdy stainless steel construction. It is made in the USA. Application, this pin will fit 2 1/2 inch and three inch trailer hitch receivers. The pin diameter size is 5/8 of an inch. Overall length, end to end is gonna be right at 5 1/4 inches.

The usable length, which basically will be from under the head here to where that clip hole starts, where the clip will go. And you can see that's gonna be right at four inches of usable length. Now, one thing I do wanna mention is that this is for the 2 1/2 inch and three inch hitches. If you want one for two inch hitches, we do sell one separately. It's a little bit shorter in length and we sell that on our website. It's part number 325-GH-096. But that should do it for the review on this Gen-Y Hitch 5/8 inch diameter stainless steel pin and clip for 2 1/2 inch and three inch hitches..


Questions and Comments about this Video

Info for this part was:

Employee Andrew K
Video by:
Andrew K
Employee Jeff D
Installed by:
Jeff D
Employee Colin H
Installed by:
Colin H
Employee Cole B
Installed by:
Cole B
Employee Jacob T
Video Edited:
Jacob T

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.