Review of Fulton Trailer Jack - Side Frame Mount Jack - F1413050334

content loading



Customers compare F1413050334 to these similar products




Products Featured in this Video



Fulton Trailer Jack - Side Frame Mount Jack - F1413050334 Review


Today we're going to take a look at the Fulton F2 side-wind swing up wide track trailer jack with the eight-inch single wheel and a 1,600 pound weight capacity. This is a nice, maintenance-free corrosion resistant jack. It's made for marine, recreational and utility trailers, uses a lubricated one piece gear box right up here at the top that eliminates the need for manual lubrication. It does have a ventilation port that allows you to add extra grease if desired. It has a nice anodized finish on both the inner and outer aluminum alloy tube to prevent rust even in the harshest environment. It has a side-wind handle here, it's made of a strong plastic for durability, ease of use and a very wide wheel base that allows for increased stability.

It has an adjustable mount on the back here for adjustable mount and swivel system for easy lifting and transport. It can be adjusted to any height for mounting.The bracket range, there's a bolt right here, if you loosen it, has a range of eight inches to adjust it for bracket height. This also does swivel into position simply with this integrated easy to grip pull pin right here. Basically right now if this is mounted on, and your wheel is down, if you need to get on the road, you can actually pull this pin and release it and then you just swing the jack right up, and it'll lock into place along the trailer, and you're ready to go. And then when you get to where you're going, you'll need to release it down, just pull this to release it so you're up like that and then just swing it down just like that, very easy to do.Now this is a weld-on installation.

The weld-on mounting plate and the hardware is included. You'd weld that onto your trailer and then this would bolt on using the included bolts to the trailer. Application, this fits a three inch by five inch or three inch by four inch trailer frames. Mounting bolt pattern on this is three and a half inches center to center this way, four and a half inches this way. The lift height, you can see the side-wind handle has a nice lock on it just to push that lever down and that will release it and then you have your side-wind handle.

The lift height all the way is ten inches and you can see, it's easy to crank. You can see it raises up and then just the opposite way to lower it down.The overall height, when it's retracted like the position it is now from the bottom of the wheel to the very top is 26 1/4 inches. The overall height when it's extended will be, with the handle down, 36 1/4 inches. With the handle up, fully extended, 41 and 1/4 inches. Now the height from the bottom of the wheel to the center of the bottom mounting hole right here is going to be 12 inches and when it's extended, it's 22 inches.

The wheel diameter itself is eight inches. Pull pin diameter right over here is 9/16 of an inch and the weight capacity again on this is 1,600 pounds. That should do it for review on the Fulton F2 side-wind swing up wide track trailer jack with the eight-inch single wheel and a 1,600 pound weight capacity.


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Jeff D
Video Edited:
Dustin K

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.