Checking Out the Fastway e2 Weight Distribution Shank Video

Eight inches from the ground to the bottom of your weight distribution shank would be fine for most situations but like you've experienced turning into inclined driveways can cause it to drag. Your trailer must sit pretty low to call for your…

Your weight distribution system uses a Shank #FA92-02-4100 that gives you a maximum 6-1/4" of rise and 2-1/4" of drop. I recommend using the Fastway Shank #FA92-02-4214. This will give you up to 10" of rise and 7-1/4" of drop with…

The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA94-00-0600 will allow you to use the Fastway e2 Weight Distribution Shank #FA92-02-4214 to get the extra clearance you desire without compromising the capacity at all.

Fastway is made by the same company as Equal-i-zer; The Fastway brand is an entry level company and the Equal-i-zer is the higher line. So the Equal-i-zer Weight Dist Shank #EQ90-02-4300 is essentially the same as the Fastway e2 Weight Distribution…

Yes, the Fastway e2 Weight Distribution Shank part #FA92-02-4214 that you referenced does have the standard 3/4 inch diameter holes that are 1-1/4 inches apart. This shank fits nearly all standard weight distribution heads from a variety of brands…

The Fastway e2 Weight Distribution Shank #FA92-02-4213 is a great option, but if you're needing a little more drop then I recommend picking up the Shank #FA92-02-4214 instead because it offers an additional 2" of drop so you can achieve the…

All you need is a ball mount that allows you to tow the trailer level. You can measure for the amount of rise needed to select the correct model. A ball mount with rise is needed when the trailer coupler is higher than the hitch receiver on the…

The measurement from the top of the Fastway e2 Shank, #FA92-02-4214, to the center of the top first hole is 3-5/8 of an inch. Each hole after this first hole will be an 1-1/4 inch apart. The last hole or the bottom hole furthest from the hitch shank…

The bolts that hold the head to the shank for the Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0600 are 3/4-10 x 5” Grade 5 Bolts. If you're asking about the size of the hitch pin then that would be 5/8". We do have the…

When it comes to installing a weight distribution on your 2019 Chevrolet Silverado 2500 when towing a 24 foot 10,000 pound car hauler I recommend The Fastway e2 Weight Distribution w/ 2-Point Sway Control - Trunnion - 12,000 pounds GTW, 1,200 pounds…

Yes, the AirBedz Rear Seat Air Mattress, #341028 would be great for a dog. However, I suggest placing a blanket over the top of it.

Yes, the Equal-i-zer Weight Dist Shank part #EQ90-02-4900 will work with the Fastway E2 weight distribution system such as the Fastway e2 Weight Distribution w/ 2-Point Sway Control part #FA94-00-0600. As long as the 10" of rise and 6" of…