All About the Replacement Bolts for Equal-i-zer Weight Distribution Head Video

Hey Ben, thanks for reaching out! We actually have the Replacement Spacer Rivet #EQ90-03-9105 which is the Equal-i-zer brand, but we found it to be the same as the Fastway Rivet 92-04-9650 so we decided just to carry one of them. Did your rivets…

Hi Cory, You can pick up the replacement snap-up lever right here for your Equal-i-zer Weight Distribution Hitch #EQ37140ET. For that, all you need is the following: - Replacement Snap-Up Lever for Equal-i-zer Weight Distribution Systems…

The Replacement Bolts for Equal-i-zer Weight Distribution Head part #EQ90-02-9100 contains four 3/4" flat washers that go on the bolt that attaches the head to the shank (see photo (#17)). If you instead need the washer that controls the head…

Yes, weight distribution shanks are interchangeable from manufacturers, so your Fastway #FA92-00-0600 can use an Equal-i-zer shank like the Equal-i-zer Weight Dist Shank - 12" Long - 8" Rise, 4" Drop - 600 to 1,400 lbs TW…

The 10K and 12K Equal-i-zer Weight Distribution Systems like part #EQ37100ET and part #EQ37120ET use different heads and spring bars so if you wish to switch back between the two capacities you will need both of these items which I have listed for…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

Picking out the correct slide topper for an awning does get confusing but Solera has told us that the way to do it is to measure the width of the slide out including the flange that goes around the outside and with that dimension find the awning that…

For the head of Equalizer systems the torque rating is tighten the angle set bolt until it comes into contact with the shank and lifts the head to where the spacer rivet also comes into solid contact with the shank. Tighten the angle set bolt an…

To install the etrailer Trailer Hitch Receiver #e73ZR on your 2019 Jeep Cherokee Trailhawk you will need the following tools. Torque Wrench #ALL944001 capable of 139lb-ft torque Ratchet Set #PT64VR with 13mm, 15mm, 21mm, and 3/4" sockets,…

It sounds like you have the 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles #e54SR which are 25-1/8". This measurement is taken with the leaf spring relaxed from center of bolt hole to center of bolt hole. With them holding the weight of the…

We don't have a way to look up the length of your leaf springs as that's not something that a record was kept for. But I can say that nearly every 3,500 lb axle spring out there needs the 25-1/8 inch replacement like the part #e54SR so while…

Curt TruTrack Weight Distribution System w/ Sway Control - Trunnion - 10,000 lbs GTW, 1,000 lbs TW Item #C17500 uses standard bolt sizes, not metric. The 3/4" bolts that hold the head to the shank get torqued to 200 foot pounds each. The nuts…