bing tracking image

Review of Curt Hitch Pins and Clips - Standard Hitch Pin - C21410

content loading

Customers compare C21410 to these similar products




Products Featured in this Video



Curt Hitch Pins and Clips - Standard Hitch Pin - C21410 Review


Jeff: Hello, everybody. This is Jeff at etrailer.com. Today, we're going to take a look at this Curt Class 1 and Class 2 hitch pin and clip for one and a quarter-inch hitch receivers. Now, this hitch pin will secure your hitch mount and accessory in your trailer hitch receiver. It is a nice heat-treated steel, which makes it strong and durable. Has a nice sink finish to resist corrosion.

Now, if you notice the pin right on this end and the clip right here on this end, they do have plastic grips on it. Makes it easier when you're installing the clip to the pin or removing it.Few specs on this. The application, it fits one and a quarter-inch by one and a quarter-inch trailer hitch receivers. The pin diameter, itself, is a half an inch. Overall length from this end all the way to this end is going to be right at three and a half inches.

And the usable length would be once you put your pin in there, the amount that's from that pin right to there, is going to be right at two inches. But that should do it for the review on the Curt Class 1 and Class 2 hitch pin and clip for the one and a quarter-inch hitch receivers.


Questions and Comments about this Video

Info for this part was:

Employee Jeff D
Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.