View Cart

Curt Brake Controller C51451 Review

content loading



Customers compare C51451 to these similar products




Products Featured in this Video



Review of Curt Accessories and Parts C51451


Today, we're going to review Part Number C51451. This is the Curt Custom Wiring Adapter for the Curt Trailer Brake Controllers. It's a dual plug in design. This is a custom fit application. This is designed to fit the Chevrolet Silverado and GMC Sierra Truck starting in 2014. What I would recommend is to go to our website, use our fit guide, put in your year and model vehicle.

It will show if this will work for your application. This is a plug in wiring adapter which allows for a quick, simple, installation of your electronic brake controller. There is no cutting or splicing required. Basically, the custom connector end right here, will plug into your factory, built in, brake controller port on your vehicle, usually beneath the dash. The other end right here, will plug into the back of your Curt Electric Brake Controller. This is compatible with the time delayed and proportional brake controllers from Curt. I have an example here, we do sell separately on our website.

This is the Curt Venturer Brake Control. If you will notice, it has the connector on the back. This harness will only work with brake controllers that have this built in plug for the adapter to connect to. It will not work on brake controllers that just have the pigtail wiring harnesses. Basically, when you go to install this, just line it up with the connector right here.

Push it in, it locks into place. You go to your other end, and on your other end, you would just connect this to the factory built in brake controller port that's on your vehicle. With that all connected, you'll be ready to use your brake controller. If you want to disconnect your brake controller, just push down on this lever right here, and it will pop the brake controller right out of the harness. This harness is about 2 feet long. It does use 12 gauge wiring and it has a protective wire loom over it, to help prevent damage to the wires.

That should do it for review on Part Number C51451, the Curt Custom Wiring Adapter for the Curt Trailer Brake Controllers. .


Questions and Comments about this Video

add comment

Info for this part was:

Written by:
Lindsey S
Edited By:
Leah B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.