Carr Hitch Step - Flip-Down Step - CARR183142 Review

content loading



Customers compare CARR183142 to these similar products




Products Featured in this Video



Review of Carr Truck Bed Accessories Carr183142


Today, we're going to review part #CARR183142. This is a Carr hitch-mounted step for two inch trailer hitches with the US Marine Corp logo. This will provide a quick easy access to your vehicle's truck bed, your cargo area, or your roof rack. Basically, you just lower it down, use it as a step and it flips up when it's not in use for a nice look. It does have the US Marine Corp logo on the bottom of the step, it shows when the step is folded up. It offers sure footing with a non-slip surface when you step on it.

It does slide into your trailer hitch receiver, keeping out dirt and grime. The pin and clip for the hitch lock is sold separately, we do sell that on our website as a related product and it is required to secure this to the hitch. This is constructed of a sturdy rust-proof die-cast aluminum, has a nice polished finish which offers a very nice touch of class and it is made in the U.S.A. The application on this is 2 inch x 2 inch trailer hitch receivers, weight capacity on this when you step on it is 650lbs, and just to give you quick dimensions on the platform itself, it is 5 inches long and right at - let's see if we can get a good measurement on the width - 2 1/2 inches wide. It does come with a limited lifetime warranty. What I wanted to show you, is, I got an example here. Here's like a 2 inch hitch receiver opening. What you would do is, you notice you've got two holes here so you just line up the correct hole, push it in, again get your pin and clip that we do sell separately, line the hole up, slide your pin through, put your clip on there, hold it into place.

Now you can use it to step up into your truck bed or roof rack, whatever you need. When you're not using it, just flip it up and it gives you a nice US Marine Corp logo and a nice shiny finish. And then to remove it, just take the pin and clip out, and you can slide it right out of your hitch opening. That should do it. For the review, on part #CARR183142, this is the car hitch-mounted step for 2 inch trailer hitches with the US Marine Corp logo. .


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Zack K
Installed by:
Jeff D
Video by:
Andrew K
Video Edited:
Jacob T

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.