Customers compare CAM39761 to these similar products
Products Featured in this Video
Hey everyone. I'm Ellen here at etrailer.com. Today we're taking a look at the RhinoFLEX RV sewer hose. This gives you a nice connection between your RV and the sewer inlet on a dump station, so you can get everything emptied out of your black water tank. So you can go out on your next adventure or put your RV away for storage for the season.This has been updated over the years. It's been around… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Videos
Help Articles
Expert Answers
Hey Chynna, the Lippert Tread Lite steps part #LC353543 that you referenced is a complete step kit. It includes the motor, gear box, control module etc. Basically it comes with everything needed to complete the install.
view full answer...Hey Ron! We have quite a few replacement options for RV steps and step components. If you could comment below with a part number off of yours I would be happy to check out what options we have. If you can't find a part number the manufacturer and…
view full answer...For a double step that is 24 inches wide and is a manual pull out step we have the part #SMFP-2100 which is pretty similar to the #LC353543 without the motor.
view full answer...While we don't have an install video for the specific Tread Lite step you mentioned part #LC353543 I did attach an install video for a similar Lippert Kwikee step that will show you the basics of a step install for you to check out.
view full answer...The Replacement Control Module for Lippert Electric Coach Step #LC301702 is the correct fit for your Lippert Coach step. The long green wire with the ring terminal is your ground and will be attached bare metal to metal on our coach frame. The short…
view full answer...If you check out the diagram I attached you will see how the steps should get wired up. What I would first do is verify that you have voltage in all of the right places on your steps to determine if the module needs to be replaced with the #LC301702.…
view full answer...We do have a wiring diagram for the Lippert Components Kwikee Step Rocker Switch #LC371010. I have attached a clip from the installation instructions that demonstrates how to wire this for you to check out.
view full answer...If you were to install the Lippert Components Kwikee 25 Series Triple Electric Step part #LC3658373 using only an on/off switch then you could wire this directly to the battery using the attached diagram. The control unit would not be used for this…
view full answer...To bench test the Motor #LC183058 on your Lippert Electric Tread Lite Step #LC353620 you can simply connect the motor wires a 12 volt battery source to operate the motor. The motor is reverse polarity so you can run it in and out by alternating the…
view full answer...The shipping weight of the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control - 6,000 lbs GTW, 600 lbs TW #EQ37060ET is 98 lbs. This weight is not added to the tongue weight of the trailer hitch or the GVWR of the trailer when determining…
view full answer...The two orange fittings at the ends of the RhinoFLEX RV Sewer Hose, part #CAM39761, are designed to come of easily. The ends can be removed by twisting the black locking rings until loose. From there, you can unscrew the orange fittings. This makes…
view full answer...The fittings of the RhinoFLEX RV Sewer Hose with Swivel Fittings, 4-in-1 Adapter, and Storage Caps #CAM39761 will not fit in your bumper that is 3-3/4 inches (the bayonet fitting on this is the standard 4-3/16 inches), but the fittings are actually…
view full answer...