Review of Bulldog Trailer Jack - A-Frame Jack - BD1700100301

content loading

Customers compare BD1700100301 to these similar products




Products Featured in this Video



Bulldog Trailer Jack - A-Frame Jack - BD1700100301 Review


Today, we're going to take a look at the Bulldog sidewind A-frame round jack with a 15 inch lift and a 5,000 pound lift capacity. Now this is a dependable jack. It recognizes the industry standard for agricultural and commercial applications. It is ASABE compliant. It does use precision fitted parts to provide exceptional stability and reliability. And this can be either a weld-on or bolt-on bracket that'll mount to any standard A-frame coupler.

To use it as a bolt on application. Now, the mounting hardware is not included. You would have to supply that, but if you notice the three holes. The Bolt holes. They are measured at the industry standard dimension of three inches center to center.

So will fit most A-frame couplers. The sidewind handle right here has a nice, smooth ergonomic design for easy cranking. You crank it clockwise. It'll raise the jack. You go counter-clockwise, it'll retract it.Now the outer and inner tubes are all zinc finished.

You can use a footplate or caster assembly on this. We do sell those separately. We do list them on this product page as a related product, and basically either one would slip right on there, and then you put a Snapper Pin through there to hold it into place. A few specs on this. We're going to measure the bracket height in the fully retracted position.

So it's going to be from the bottom here to the bottom of the mounting bracket. So that's going to measure right at eight and five eighths inches. Now, if we did crank this out all the way has a lift or a travel of 15 inches. So if we would measure that same measurement from the bottom to the bottom bracket, it'll measure 23 and five eighths inches.Now the clearance measured from the mounting bracket to the top of the jack. That is going to be measured right at 14 and three quarter inches. The handle radius from here to here. Is going to measure right at six and 11 sixteenths of an inch. And the outer tube diameter is two and a quarter inches. Inner tube diameter is two inches. And as we've mentioned, the lift capacity is 5,000 pounds. So again, you just crank it clockwise to raise it and counter-clockwise to lower it. But that should do it for the review on the Bulldog sidewind A-frame round jack with a 15 inch lift and a 5,000 pound lift capacity.


Questions and Comments about this Video

Info for this part was:

Employee Jeff D
Installed by:
Jeff D
Employee Cole B
Installed by:
Cole B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.