bing tracking image

Bulldog Camper Jack - Landing Gear - BD500153 Review

content loading

Customers compare BD500153 to these similar products




Products Featured in this Video



Review of Bulldog Camper Jack BD500153


Today we're going to take a look at the Bulldog Weld-on 2-Speed Tandem Landing Gear Set. It has a 17 inch lift, and 45,000 pound lift capacity. This landing gear set will include a 1 single-speed jack, a 1 2-speed jack and they're designed to work in tandem for your heavy duty towing applications. The sidewind crank right over here is included. The cross shaft that will connect the 2 jacks is not included, that would be sold separately. This set is ideal for horse, livestock and heavy-duty trailers. The 2-speed jack over here makes cranking faster and easier.

You have a low gear which will give you full lifting power, which will offer smooth and easy ratio of one inch for every 27-1/3 turns. The higher gear will give ultimate speed, which will move the jack 1 inch for every 4-1/2 turns. It does use the traditional gear box design which will require you to reposition the crank to switch gears, and again the sidewind crank is all included. It does have easy to access grease soft fitting, as you can see 2 over here, 2 right here, and even 1 over here for the gear box. The heavy duty steel leg band at the very bottom, right down here you can see on the right bottom of the jack, that provides extra strength and support. On the inside it does use a high-efficiency, double-lead screw.

The very bottom you can see the large shoe, it's a self-leveling sand shoe which offers really good stability. Again the set includes the 2-speed jack right here, the single speed jack, and the crank. The cross shaft again is not included. You would have to buy that separately or have one made to match the width of your trailer. To install this, it is a direct-weld design. The finish on both of these has nice black paint coated finish. A few specs on this, we're going to give you the measurements.

I have both of these jacks in a fully retracted position. The measurement on the retracted position is going to be from the ground, it is going to be right at 31-11/16, and then it also has a 17 inch lift. If we crank this up, fully extended position as far as it could go would measure 48-11/16. The lift capacity again is 45,000 per set, and the static capacity per set is 90,000 pounds. That should do it for the review on the Bulldog Weld-on 2-Speed Tandem Landing Gear Set, 17 inch lift, and 45,000 pound lift capacity.


Info for this part was:

Employee Jeff D
Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.