Blaylock Industries Lunette Ring Locks - - BLTL-60-40D Review

content loading



Customers compare BLTL-60-40D to these similar products




Products Featured in this Video



Review of Blaylock Industries Locks BLTL-60-40D


Today were going to review part number BLTL-60-40D. This is the Blaylock Easy Lock Trailer Coupler Lock with the included Master Lock padlock. This coupler lock will prevent theft of your trailer that has a lunette ring coupler and accepts a pinto hook. Basically after this locks been secured to your coupler it will ensure peace of mind by keeping would-be thieves from hooking up the lunette ring on your trailer to a pinto hook. Basically the way you would install thisnow this does fit lunette rings with a two and a half inch or three inch inner diameter ring. I have an example here of a three-inch lunette ring.

Basically the way that would work is you would position these two aircraft grade lightweight aluminum pieces which are strong and durable and rust-resistant. Place one on the bottom. Take the other one and place it on top. Have the holes line up and you have this three-quarter inch diameter steel pin, which will slide through both pieces. Youll see you have this three-eighths inch diameter hole that will be exposed here on the bottom.

Youll take this stainless steel Master Lock padlock which has a hardened steel shackle, just three-eighths inch in diameter and that will attach to this pin to keep the lock into place. This shielded shackle design will prevent access with bolt cutter. This lock is resistant to wear and corrosion. It has two keys which are included, and the can be keyed alike to match your other coupler locks that require a padlock. Basically what you would do is run the shackle through the pin and then it will be locked into place.

The two pieces will be locked, one on top, one on bottom. As you can see with this coupler installed on your trailer, and the lock on the bottom there would be no way that anybody could put a pinto hook through there and drive off with your trailer. This part is made in the U.S.A. and again it will fit most lunette ring couplers with a two and a half inch or three inch inner diameter opening. We do sell this padlock separately.

If you just need the padlock its part number ML40D. We also sell just the coupler lock separately, without the padlock if you have your own padlock. The part number on this would be BLTL-60. That should do it for review on part number BLTL-60-40D.


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.