Blaylock Industries Trailer Coupler Locks - Surround Lock - BLTL-20 Review

content loading



Customers compare BLTL-20 to these similar products




Products Featured in this Video



Review of Blaylock Industries Locks BLTL-20


Today were going to review part number BLTL-20. This is the EZ Lock Trailer Coupler Lock. This coupler lock is designed to prevent theft of your trailer. This is a simple installation. Basically a heavy duty bracket will secure around your trailers coupler. The raised ball on the platform will sit inside your trailer coupler and then will fit on your trailer coupler.

The 3/4-inch diameter steel pin will slide through the bracket and over the coupler and then when you put a lock through here that would actually lock the coupler in place to keep it from coming off. Now it does use a padlock. It is sold separately. I have an example of one we sell which is the Disc-Style Padlock, part number DT40124. I just want to show you.

If you open that up, run the lock through it that will lock that pin over the coupler. Now the pin hole is designed to fit on a 1-7/8-inch, 2-inch, 2-5/16 Bulldog Collar-Lok Style Coupler and I want to show you that type of coupler. This is a Bulldog Collar-Lok. Its different than any of the other locks or the couplers. Basically this one is if you lift up on the latch, as you can see, as I lift up on the latch, it will release the collar.

Its spring loaded. It pops out to allow you to put it onto the ball. What Im going to do is demonstrate it on this lock here. If we put this onto the--if this coupler was on your trailer, you put that on and when you install this you want the slanted side to point towards the front of the trailer. Slanted sides pointing towards the front.

Basically you just touch it back down and then to lock it into place, you take the 3/4-inch pin, put it over the coupler and put the lock into place. As you can see, it locks it in there. That will keep the coupler from being connected to another hitch ball. Nobody will be able to attach to it. This lock itself is an aircraft grade lightweight aluminum construction which is strong and will resist wear and corrosion. The part is made in the USA. Now it does fit most trailers with the 1-7/8 inch, the 2-inch and the 2-5/16 Bulldog Collar-Lok Style Couplers, just like this one here I demonstrated. Again, the locking pin diameter is 3/4 of an inch. A few measurements on this, the width is 4-1/2 inches. The length is 2-1/2 inches. The overall height is 5 inches. Again, this part is made in the USA. After your coupler has been secured, this lock will render your trailer coupler inoperable which will ensure inaudible 0:03:35. Again, I just wanted to reiterate when you install this, the slanted portion which you can see here, the coupler would be back here and the slanted portion would be facing the front of the trailer. That should do it for a review on part number BLTL-20.


Questions and Comments about this Video

add comment

Info for this part was:

Installed by:
Jeff D

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.