A Closer Look at the Replacement Bearing Buddy Bras Video

The Replacement Bearing Buddy Bras Model 17B, part #BB17B, will fit on Bearing Buddy grease caps for hub bores from 1.781-inches to 1.810-inches. These caps will have an outer diameter of close to 2-inches. Because these bras are made of flexible…

Bearing Buddy pumps grease into the center of the hub all the way back to the grease seal. A double lip seal should be used to prevent grease from blowing out the seal when added. When the hub and seals and bearings are first assembled, they should…

If you have the old bearings and seals, it is possible to find the part numbers stamped into them. If these do not have numbers or if they have worn off over time, you will need to take some measurements. I recommend using a digital caliper like the…

Your Magic Tilt boat trailer uses UFP hubs and bearings. In my research I found that your spindles are compatible with the L68149 inner and L44649 outer bearing and the 10-19 grease seal. For the proper replacement hub, use #AKIHUB-545-35-K which…

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

As long as it's the correct size for your spindle it does not need to fit super tight as the o-ring provides the seal that allows it to not leak.

For a Bearing Buddy that has an outer diameter of 2 inches you would want the cover part #BB23B.

Unfortunately, no we do not carry axe sleeve repair kits, so your options would be to replace the entire axle, the spindle, or you can just use the Spindle Grease Seal Set for L44643 Inner Bearing and 1.980 Bearing Buddy #BB60001. This kit is…

Based on the diameter of the Bearing Buddy that you measured the correct replacement bra or cover is the part #BB19B you mentioned.

When installing the double-lip grease seals like #BB60001 that are needed when using Bearing Buddy bearing protectors like #BB1980A-SS you want to install the rear grease seals as gently as you can, to avoid any deformation of their shape, and only…

We have a few options that are right at 1.98 inches outside diameter but I'd need to know what the diameter of the spindle is where the seal rides to know for sure. Like part #RG06-020 has an inner diameter of 1.5 inch. Part #RG06-010 has inner…

It sounds like you are looking for the correct grease seal for your spindle. If your inner bearing is part #L44643 and the grease seal journal, or mounting location, on the spindle is 1.25 inches, then you have two grease seal options. For a standard…