Baron and Baron License Plates and Frames - OEM - HDLPD86 Review

content loading




Review of Baron and Baron License Plates HDLPD86


Today we're going to review part number HDLPD86. This is the Barren and Barren Harley Davidson License Plate with the Vintage Logo Cutout Emblem on the front. This plate is a stainless steel 1mm gauge ridge plate. It has a nice polished mirror finish. It uses the vintage bar and shield logo. It has a black fill color on a chrome finish cut out emblem. The emblem is securely attached to the center of the plate.

If you turn it over you can see the 4 screws that hold it on. This part does come with the 4 chrome screw caps. When you install it you just have to supply the screws or use the screws that are already on your vehicle. The frame measures total width right at 12 inches, total height top to bottom is right at 6 inches. This is an officially licensed product. The caps that come with it have the chrome cap over it and then the plastic washer.

Basically what you do is when you go to install your plate you put your screw through that washer and go ahead and tighten it down, just like that, on all 4. Once their all tightened down you can just take the cap and it will snap right over the top and hold into place and give a nice clean finish to your chrome license plate. That should do it for the review of part number HDLPD86 the Barren and Barren Harley Davidson License Plate with the Vintage Logo Cutout Emblem. .


Questions and Comments about this Video

add comment