2009 Chevrolet Avalanche Truck Bed Sliding Tray

The Truck Trolley Sliding Truck Bed Tray #TR87VR actually just installs using straps, which is why it has a 300 lb weight rating as opposed to 1,000 + lbs like we see with some of the sliding cargo trays that bolt to the truck bed. The installation…

Truck Trolley test fit the part #TR87VR on the 2023 Ford F-150 and found that it does fit the 5-1/2 foot and 6-1/2 foot beds so it would for sure fit yours. We also had the chance to test fit it on a 2020 model and found that it fit and worked…

Thanks for reaching out, Joe! I recommend using the Rhino-Rack Aero Bar Roof Rack for Camper Shells #Y02-480B which comes with 63" long tracks as well as 54" long crossbars which should give you a little bit of overhang on…

Yes, the Truck Trolley Sliding Truck Bed Tray #TR87VR does slide out of your truck bed. It has wheels built into the bottom of the tray. This is capable of supporting up to 300lbs and will extend 12-18" beyond your tail gate.

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and might make the ride quality a little rougher but it would fit…

Hey Kevin thanks for your question. There is not much downside to going with the 5,000 lb springs instead of the 3,500 lb. A higher rated spring may make the ride a bit more "chunky" at times, since the spring would not flex as…

The trailer hitch that fits your Supercharged 2015 Land Rover Range Rover comes from Stealth Hitches and is available in 2 different variations: - With Accessory Receiver Only #SH49GR - With Accessory Receiver and Towing Kit #SH46GR I really like…

The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase you'd want the part #MR29DR or if you have a 33 inch wheelbase…

We do carry the 33" Ark Stabilizer Jack that you are looking for with part #ARK77FR. I was able to track down a few drawings that you should find helpful. These are for the 30" #ARK94FR and the 24" #ARK34FR Stabilizer…

Hey Clayton, the correct Westin hardware kit for the E-Series steps part #23-2315 that fit your 2008 Dodge Ram 2500 quad cab is the part #23-231PK.

The brackets on the SumoSprings Trailer Helper Springs #SS26MV are 1-1/2" wide so they will fit evenly across the humps on your spring pads. I do not recommend cutting down the spring and you will be able to use these even with only having…

Yes, it will. The Roadmaster Battery Disconnect with Switch for Towed Vehicle w/ Flat Tow Brake System item #RM-766 is not only compatible with your 2024 Buick Encore GX but it is recommended to be used by Roadmaster. This a great part that makes…