Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Roadmaster lists the height of the baseplate attachment point on a 2022 Jeep Wrangler Rubicon with factory tires at 16-1/4". This means you're 7-3/4" off from level and would need to use a high/low adapter like the Blue Ox…
view full answer...There are two airlines that must be spliced into on the coach which will then run to the air tank assembly included with the SMI Air Force One Supplemental Braking System part #SM99243. One of these lines is for supply-air and the other is for…
view full answer...The Grand Design Imagine XLS 17MKE weighs in at 6,395 lbs fully loaded so for an appropriately sized weight distribution system, I recommend the Reese Pro Round Bar Weight Distribution part #RE94FR which is rated for up to 8,000 lbs. This system will…
view full answer...The L-brackets of the Reese weight distribution system #RE44FR need to install between 24.5 and 27.5 inches from the hitch ball center. I attached a picture that I took from the instructions that shows this. The range gives you a bit of flexibility…
view full answer...The Reese #RE44FR would indeed offer weight distribution and sway control. The kit includes a 2-5/16 inch trailer ball and the adjustable weight distribution shank. The system is rated for trailers with a 600-1150 lb fully loaded tongue weight. You…
view full answer...Determining the correct rise or drop for your Blue Ox SwayPro Weight Distribution System #BXW1000 is going to be the same method as determining rise or drop for a standard ball mount. You will just need to measure from the ground to the top of your…
view full answer...There's no functional reason the Blue Ox High-Low Adapter for Tow Bars #BX88235 uses bolt instead of welds that you would notice. By that I mean there isn't something different you can do with it based on the bolts like swap to a different…
view full answer...On the 2010 Lexus GX460, the Curt Trailer Hitch, #C13043, will bolt to existing holes underneath the bumper beam. The holes in the bumper beam bracket will have existing weldnuts already in the bracket, so you will just line up the holes on the hitch…
view full answer...Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…
view full answer...Curt T-Connector 4-Pole Vehicle Wiring Harness #C56224 is a confirmed fit for your 2015 Volvo S60. I verified with Curt that this 4-pole kit works on all versions of the 2014, 2015 and 2016 model year S60. Installation of this harness is mostly a…
view full answer...Ball mounts like the Curt #C45100 are available in various lengths. This one happens to be 13-inches long, longer than some. Longer ball mounts are needed, for example, in cases of a truck having a slide in camper in the bed, or when using a…
view full answer...Both the Convert-A-Ball shank, #AMAC1, and Curt shanks have hole spacing of 1-1/4 inches on center so you can use the AMAC1 on a Curt weight distribution system. I have included a link to a video review of the AMAC1 for you.
view full answer...Filter Your Search
Contact and Help