Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Curt 7-Way RV-Style Trailer Connector - Vehicle End #C58155 will connect to the Hopkins 7-Way RV Style Connector with Molded Cable #H20046 to make an extension with the following pin to color combinations because Hopkins uses odd colors. White…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...The receiver with the best clearance is the Curt Trailer Hitch Receiver #13364 which has a hitch pin hole to rear bumper length of 4". The height to the top of the receiver tube is 12-1/4" The etrailer Trailer Hitch Receiver #e98854…
view full answer...The etrailer brand #e98854 Class III hitch would install using hardware that is already existing on the vehicle, so no separate hardware is needed. You can see this by consulting the linked installation instructions or taking a look at the linked…
view full answer...The distance from the center of the hitch pin hole of etrailer.com Trailer Hitch Receiver #E98854 to the edge of the rear fascia (or the edge of the rear bumper) on your '10 Town and Country is approximately 4 inches. For wiring which will give…
view full answer...The Curt Weight Distribution Shank part #C17132 offers up to 9-1/4" of drop. In order to see if this is enough for your truck/trailer combo you will need to take some measurements. If the distance from the ground to the top inside edge of the…
view full answer...There is a weight distribution shank that can give you 6 inches of drop and fits a 2-1/2 inch hitch. Weight distribution shanks are designed in a way that allows you to use a shank from a different manufacturer than the hitch itself, so what you can…
view full answer...I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…
view full answer...The Gen-Y Torsion 2-Ball Mount #325-GH-1824 that you referenced does now come with set screws on the sides of the square openings to allow the movement of the ball and retainer to be reduced. I attached a picture of them for you to check out. The…
view full answer...You are correct about ball mount #EA80. The ball platform is indeed 1 inch thick. The 2 inch ball #63852 does not have a long enough shank to be used with this ball mount. You will need a 2 inch ball with a long shank such as #63849. It isn't…
view full answer...Brophy hitch ball #SC23-C is made overseas. For a stainless steel option that is made in the US you would have to go to an interchangeable set, #903B. I have linked a video review of this set for you.
view full answer...If you put on a Hitch Extender #HE06 you will reduce your trailering capacity to 350lbs tongue weight and 3,500 total trailer weight. Most of the receiver extensions with that much rise include a gusset for strength that may prevent the Curt Clamp-On…
view full answer...Related Searches
Filter Your Search
Contact and Help