Round trailer axle beam measures 95" from hub face to hub face (when hubs - sold separately - are mounted) and 80" from spring center to spring center. E-Z Lube spindles make it easy to lubricate bearings (sold separately).
Trailer axle measures 95" from hub face to hub face and 80" from spring center to spring center. Includes electric brake assemblies, hubs, drums, bearings, races, seals, and mounting hardware. E-Z Lube spindles for simple lubrication.
Straight trailer axle measures 95" from hub face to hub face and 80" from spring center to spring center. Includes idler hubs - with bearings, races, and seals - for 13" to 15" wheels. E-Z Lube spindles for simple lubrication.
You may be able to replace your existing axle that has an 84 inch hub face length with one that has an 89 inch hub face length without a problem but it's going to be dependent on your existing spring center length. This is the distance from the…
You can actually measure the bolt pattern of a wheel in either way that you mentioned. I attached a picture that shows how to measure across center of the wheel to determine the bolt pattern but if you have a 5 lug bolt pattern you can also measure…
The axles on your tandem axle trailer are 4,400 lb AL-KO axles. The tag says 4,400 lbs max capacity, so that is what you need to follow. The brake drum size and bolt pattern do not determine axle capacity. If you want to replace these axles, I…
You are describing a spindle like #TRU37FR but it uses a tang washer, not a cotter pin because of the grease fitting. The problem is that aftermarket spindles are under rated compared to the OEM counterparts. This is actually not a bad thing because…
You may want to double check your 5 way from your vehicle, because normally the stop and turn signal functions are combined on a single wire and are separate wires based on left side and right side for turn signal. So, you'd have ground, left…
On grease seals the TB means a low pressure, double lip seal with a spring and the VB means a non-pressure, single lip seal without a spring. The seal you will need for the part #171255TB is the TruRyde Grease Seals-Double Lip, part #RG06-050. This…
There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…
After you've packed the bearings and assembled everything, carefully slide the hub assembly onto the spindle and install the outer bearing. Install the spindle and tang washer and run the spindle nut down finger tight, then rotate the hub back…
You're right when referring to the #5 pin at the 10 o'clock opposite the ground wire when looking at the back of the trailer side connector. This should be the pin that corresponds to the brake controller output, but this will also depend on…
We don't offer an 8500 lb rated surge coupler, but we might have options that would work for you. If the GVWR (weight of trailer plug boat) is 8000 lbs or less, I'd recommend the Demco item #DM8669113 if your trailer has disc brakes or item…
The correct replacement axle for a Quality 3500 Lb 95 HF 80 SC is the Dexter Trailer Axle Beam with E-Z Lube Spindles part #7359765. This option will be a direct replacement with no modifications needed. If you want to replace the brakes and…
The Experience Has Been Great.The People I Have Spoken To Have Answered Any Questions I may have had. I have Nothing But positive Thoughts About The Company. I Will Purchase again!!!!!!!
Filter Results
