Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The switch on your wall is only turning the power on and off for the fan. With a powered lift there wouldn't really be a way to tap into the function and wire it to a switch to make it easier to access. The only option would be to replace…
view full answer...Two Door Latches that I would recommend are the same thing, just in two different colors. TheGlobal Link RV Entry Door Locking Latch Kit comes in Polished Chrome #295-000002 and black #295-000019. The Dimensions are 3.47 inches wide x 4.28 inches…
view full answer...The Ventline Exterior Wall Vent for RV Range Hood, #V2018-01 does not have a screen. The vent is 11-1/2" by 5-1/2" with a 10 bolt pattern. Please note the linked product review video. the holes are set in from the edge by about…
view full answer...The gauge used with the heavy duty Air Lift compressor system, #AL25854, has 4 wires because the switch is built into the gauge. The black wire is the ground, white is the signal to the compressor, red and green are ignition power wires. I have…
view full answer...Definitely sounds like a bad trailer magnet due to wear that is causing your issues with low brake voltage. I attached a help article that covers how to troubleshoot them as well. Most likely you'll need to go with new trailer brake…
view full answer...You'll need to do a full troubleshoot. With the trailer unplugged, use a voltmeter on the brake pin on the trailer connector while the manual brake switch is actuated. If you have a time delayed controller, you should also get voltage on that…
view full answer...Actually the type of roof vent cover you need to attach to the vent cover brackets of your Maxxair 4951KS like part #MA00-04500K is the part #MA00-955003 which uses those brackets with the included cotter pins of the cover.
view full answer...My contact at Patrick Industries advised that their RV Heater Pad with Thermostat #277-000163 could be parallel wired in up to 3 pads total provided that the DC power source has enough current for the 5.8-amp draw from each pad. Typically a 15-amp…
view full answer...The only tank that actually requires a heating pad is the freshwater one because the other tanks you can simply pour RV antifreeze into and not have to worry about heating the tanks. That said if you wanted to you could install Thermaheat pads like…
view full answer...There may be a solution for you with the Global Link RV Entry Door Locking Latch Kit #295-000019. This is a replacement for a standard entry door lock from a number of manufacturers including Fastec (FIC). It is 3.47" wide x 4.28"…
view full answer...We do have replacement RV Entry Door Handles like the Global Link #295-000019 as well as deadbolts like the Valterra #L32CS3108 with 1" throw, but these are keyed separately as we don't have an all-in-one kit with both locks keyed. Alike.…
view full answer...If you check out the attached picture it shows how the wiring on a trailer should look. If you already have all of the wiring that you need for a 7-Way and you are just wanting a way to organize it then I recommend installing the Trailer Wiring 7-Way…
view full answer...Filter Your Search
Contact and Help