Search: wire splice connectors   >  

It looks like all models of the 2005 Airstream Safari used 12" x 2" brake assemblies regardless of the axle capacity. If you want standard brakes you can use the Dexter #23-105-106. If you want the Nev-R-Adjust self-adjusting brakes then…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

There are many options out there. LubriMatic Disc/Drum Brake and Wheel Bearing Grease #L11465 is a great one. You can use it on disc or drum brakes. It can also be used to grease wheel bearings.

Thanks for the picture and info on your current brake assemblies, from that we know that the Dexter brake assembly part #23-106 that you referenced is the correct fit. For the left hand side you'd then want the part #23-105.

While we do not have an installation video I have linked a great help article we have for this near the bottom of the page. The article includes pictures of the wiring and goes into further detail about the installation on your 2014 Chevrolet…

Curt trailer hitch #14361 would certainly do the trick and it does fit your 2008 Dodge Ram 1500 SLT 4x4. But this hitch might be a bit of an overkill since its capacity is 10,000 pound gross trailer weight. It is a great option if you will be towing…

Yes the Race Ramps XT Ramps for Service and Display #RR-XT-2 would work great with a 2001 Chevy Corvette. I attached a picture of a similar C6 Corvette on these ramps for you to check out as well.

You have the 7-way at the back bumper, as well as one installed in the bed, but you don't have the wiring connecting the two, is that correct? We don't offer the wiring harness only, you'll need to use the #40167 you referred to. You can…

The Deka Jacketed 4-Wire #DW04923-1 and 7-wire #DW04914-1 both use full copper wire instead of Copper Clad Aluminum (CCA) wire.

We have the part #DW04923-1 which is a jacketed 4-way wiring sold by the foot. All you have to do is enter a quantity of how many feet you need into the quantity box and we'll ship you out that length of 4-way wiring.

I am not sure of the exact model hub and drum assembly you have on your trailer, but the etrailer.com Trailer Hub and Drum #AKHD-865-8-K that we have for 8,000 pounds axles weighs around 68 pounds. Looking through the other similarly rated hub…

First, use a circuit tester like #40376 if needed, to test the 7-Way trailer connector. The 12-volt circuit will be in the 1 oclock position. If the trailer side connector pin that corresponds with the 12-volt circuit is connected to the battery on…