Search: ts20037b   >  

You can absolutely wire up a 3-wire breakaway switch like the Hopkins LED Breakaway Switch with 7" Lead Wires #HM20059 to replace your 2-wire switch; the difference is that the 3-wire switch has a dedicated ground wire while the 2-wire…

It sounds like you need to re-calibrate the zero point on your Lippert Ground Control 3.0 #LC304136 system. Below I've listed out the steps you'll need to follow and will allow you to use the auto leveling again. Zero Point…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

There is indeed a B&W Tow & Stow ball mount that gives up up to 4-1/2 inches of drop and works with your GMC MultiPro tailgate; what you need is the following part number: - B&W Tow & Stow 2-Ball Mount - MultiPro - 2" Hitch -…

Hi Richard! It sounds like you're needing to install the Load Resistor Kit for LED Turn Signals #DI34ZR on the turn signals you've installed on your toolbox. Since LEDs don't require as much power as incandescent bulbs, sometimes we see…

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

The B and W Tow n Stow part #BW44FR does work with the GM Multi Pro Tailgate but it fits the 2 inch hitch size whereas your husband's 2022 GMC Sierra 2500 would have a 2-1/2 inch hitch size so the correct part number to get would be the part…

I recommend going with a wheel like the Taskmaster Modular Wheel in White #TA36MR or Silver #TA35ZR. These wheels only have a 0.08" positive offset keeping the center of the Provider 235/75R17.5 Radial Trailer Tire #P35175 in line with the…

Yes, for this you are going to want to take a look at a powered drive conversion kit like the Bulldog Powered-Drive Kit for Single-Speed Jacks part #BD1824200100. This kit is designed specifically for Bulldog trailer jacks but can most likely be used…

A few years ago, Ford started equipping their trucks with the so-called 'smart' trailer connectors. The 12 volt feed on the trailer connector won't supply power unless the following conditions are met: • Ignition is on with vehicle…

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from it,…