To provide a 2 inch hitch ball for your Trailer Valet XL #TVXL25 that came with a 2-5/16 inch ball, you can use the 2 Inch Hitch Ball for Trailer Valet XL Trailer Dolly #TVHB2. This part number will provide you with a new 2 inch diameter ball for…
If the front part of your square-bodied coupler is approximately 3 inches tall, based on the inner dimensions of the lock the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33 will work well for you. The #BLTL-33 has inner dimensions of 3-1/8 inches x…
Yes, the 5 on 4-1/2" bolt pattern in regards to trailer wheels is much more common therefore the selection of wheels will be much greater. The 5 on 5" bolt pattern has a slightly higher capacity but only marginally. I recommend the Dexstar…
Hello Steve. The Trimax Trailer Wheel Chock and Lock Set #TMX85FR comes with a pair of keyed-alike wheel locks. You will get two locks and 4 keys total. So, you just need to keep one key handy then put the other 3 somewhere secret and safe. This…
I went out to the warehouse and found that the thread of the bolts in the Hardware Kit #DM6166 you referenced is about 1-3/4" long while the overall length of the bolts is 2-1/8" which you can see in the attached photo.
I believe you mean Load Range since the Load Ranger was the unsuccessful brother of the Lone Ranger. For any given tire size there can be different load ranges. The different load ranges have different weight capacities. This has to do with the…
We will need some more information in order to track down a new hub to fit your assembly K-H 71744. Pull off your old hub and look for numbers stamped into the bearings. If you do not see the numbers then you will need to use 4" Carbon Fiber…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…
The 10 to 18 inch measurement is referring to the wheel/rim only - not the whole tire - for the Trimax wheel lock, which is the following part number: - Trimax Heavy Duty Adjustable Wheel Lock with Padlock - 10" to 18" Wheels #TMX42ZR
First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…
Filter Results
