Search: trailer vent covers   >  

In order to determine the correct roof vent, measure where the vent opens. The standard trailer roof vent opening is roughly 14-1/4" x 14-1/4" and have roof vents that measure 14" x 14". To pick the correct cover, you will also…

Many of the trailer roof vents use a standard 14-1/4 x 14-1/4 inch rough opening. The vent cover you choose will depend on the hinge style. I have attached three photos of roof vent covers that shows the hinge styles. Check out the vent on your…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

The biggest difference will be price. The two harnesses are basically the same harness made by two different companies. The Curt part #C55382 would be what I would go with over the Hopkins #42475 because the price is better and because we seem to…

I have attached the complete installation instructions for the Reese Universal Base Rails and Installation Kit #RP30035 that is included with the Pro Series Sliding Hitch #PS30129. This is a universal rail kit that is designed to fit most trucks. You…

Thanks for the photo, and there isn't a specific vent cover that is going to attach to those plastic tabs, but so long as your Dexter vent is the standard size, measuring 14-1/4" x 14-1/4" at the roof opening, you can use a Fan-Tastic…

I believe the tack room vent on your Sundowner is smaller than standard size vents and we don't have anything to fit your current vent. I had another customer a while back that measured their Sundowner and it was 13x13 inches so not a standard…

Yes, we do have brake assemblies for Dexter 10,000 lbs axles. You will want the Dexter Electric Brake Kit - Self-Adjusting - 12-1/4" - Left/Right Hand Assemblies item #23-450-451. These come as a set and you will need one for each braking axle…

We do actually have Dexter electric drum brakes in your required 10 x 1-1/2-inch size, parts #K23-473-00 and #K23-472-00, which are right- and left-hand, respectively. These are complete bolt-on (4-bolt) replacements that fit wheels diameters from…

For 7,000 lb Dexter hub assemblies, you could have 1/2 inch or 9/16 inch, or 5/8 inch drive in studs. I've linked the page of our drive in wheel studs for you. Once you have the right stud based on your measurements you can get the correct lug to…

The particular load range of trailer tire needed for any given application depends on the number of axles and tires. If a trailer were to have, for example, two 3500-lb-rated axles, then it would likely have a gross weight rating (GVWR) of about…

When it comes to load capacity, we typically just try to make it easy by recommending trailer tires that provide a combined load capacity that meets or (ideally) exceeds the trailer's loaded weight. With that being said when technicalities are…