Search: trailer rims   >  

We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The Dexstar Dual Wheel part #AM20783 and the Lionshead Steel Dual Wheel part #LHHA420 are two very similar wheels with a few key differences. They are both 16" diameter x 6" wide wheels with a 8 on 6-1/2" lug pattern. However, the…

We have a couple options for you to replace your 205/60-8 tire and wheel with a 4 on 4" bolt pattern with something slightly wider and taller. A 205/60-8 measures 17.7" in diameter and is 8.1" wide, and for a bigger option there is a…

For a wheel that is 5 inches in width and 15 inches in diameter you would want tires that are size ST205/75-15. For the tire size ST225/75R15 you listed you would want a rim that is from 6-7 inches in width. I attached a department page that has all…

The specs listed for the #KDBC225DAC Kodiak caliper I found online match up with those of the Reliable CL-1000. Either would be compatible with a 3500 to 6000 lb axle but because it hasn't been officially tested, If I were in your shoes I'd…

Based on my research, the Kodiak Disc Brake Caliper #KDBC225DAC should work perfectly as a replacement for the existing Reliable CL-1000 Calipers on your trailer. This hasn't been officially tested by the manufacturer but based on the specs they…

To replace the oil caps on your trailer, you can use the Kodiak XL ProLube Oil Bath Hub Body and Cap, 1.98 Inch #xlprolube1980. This oil cap replaces the body and cap, with the cap being made from a blue polycarbonate. Based on the outer diameter of…

The pilot diameter on a wheel, like the one with part #AM30620, is the diameter of the bigger hole that is directly in the middle of the wheel. The pilot hole diameter of the wheel for the part I just measured is 2.84". I have attached a picture…

Since your tire size starts with the letter P you have a passenger vehicle tire on your trailer which is not ideal since it's not rated for the vertical loads that trailers have. You want a tire size that starts with ST like the ST225/75R15…

I have a different option for you, but changing the axle tube diameter will not increase the axle capacity as the new weakest link would be the spindles which would still have a 3500lb capacity. You could start from scratch and use two of the #42 E-Z…

Looks like Maxion/Vesper wheels like the #TA56FR are made in Turkey whereas Dexstar trailer wheels are made in USA.