Search: trailer jack foot   >  

Hey TJ, I went out and opened up one of the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 boxes and found that they include a 5/8-18 x 1-1/2" fine thread grade five bolt. I then called Lippert and they…

When you are replacing bearings you do want to pack them prior to installing the new ones into your hub. This ensures that the grease actually gets pushed completely into the bearings so that they work properly and don't overheat. You can use a…

I checked with Dexter and they indicate that for hub 008-386-80: "Available for service parts only." Meaning the actual hub assembly is not available but parts for it are such as the 35mm cartridge bearing #31-72-3. There isn't a way to…

The most likely cause for the incorrect behavior of your trailer lights, where activating one turn signal causes all trailer lights to blink, is an insufficient ground (or a short to ground) on either the vehicle or the trailer. Since you re-wired…

Yes, 14 gauge wire seems too small. I would go with 10 or 12 gauge. For 10 gauge you can use #10-1-1 and for 12 gauge use #12-1-1. These wires are sold in increments of 1 foot. So if you needed 20 feet of wire you would enter 20 in the quantity box.…

You can use a 7-Way and 4-Way connector at the same time just as long as you are not overloading the light circuits. If your camper has a lot of outside lights like running lights, and brake/stop/turn lights then the lights that perform the same…

What you have on your trailer is called a 5 spoke utility hub, like part #8-174-5UC3. They're pretty common on mobile homes so I'm guessing this is where your axle came from. This is also evidenced by your 8-14.5 tires since they're often…

In regards to the Trailer Valet JXC Trailer Jack part #TV94FR, the distance from the mounting plate to the bottom of the outer tube is 7" which you can see in the photo below. I don't have any confirmed fit caster wheels for this jack but…

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14" of lift on…

Your 4-pin/5-wire wiring harness is what is called a "wishbone" type which simply means that there are two separate running light wires, one brown and one pink. This allows a separate running light wire for each side of the trailer which…

The DeeMaxx Trailer Wheel Lug Nut #DE93GR is 1.4" in length.