Search: trailer brake away switch   >  

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

Thanks for the picture. Based on that it looks like the part #T2385200 is almost an exact replacement. Normally it's used for hydraulic brake setups so I don't know how it would work for you, but if your setup has a way to make it work and…

Hi Jayme, Thanks for that info and there is a bearing kit with the L44649 and L68149 bearings you need; the correct kit is the following: - Hub Bearing Kit #BK2-100 This comes with both of those bearings as well as their accompanying races, the…

I made a video for you showing how Optronics trailer light bracket #BK5557GB works with a light. This bracket will accept the following lights: LED applications: MCL-55, MCL-56, MCL-57, MCL-527, MCL-51, MCL-58, MCL-59 Incandescent applications:…

There is a replacement that I recommend for the Tie Down 70E disc brake actuator, though you will want to verify that your mounting bolt holes are 3 inches apart on center and your tongue is a 3 inch channel. If they are I recommend the Dexter DX7.5…

The thickness of the angle steel of The Dexter Axle Torflex #11 Axle Side-Mount Frame Installation Hardware Kit Item #DX57FR is .209” (+/-.09).

The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.

The Curt SecureLatch Lunette Ring with 8-Position Adjustable Channel #CU49FR does come with the hardware needed to attach the lunette ring to the channel. It is 3 bolts, 3 nuts and 6 washers. The picture below shows every piece you would receive. If…

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

I can certainly point you in the right direction on a few of the parts you will need. Unfortunately we do not carry a 20-3/4" long equalizer, so we do not have any kits that would accommodate that hanger size and axle spacing. We do have a few…

Although we do not carry leaf springs that will work with this kit, I can tall you that the slipper springs you need for the Dexter Tandem-Axle Trailer Hanger Kit for 2" Slipper Springs - 42-1/4" Axle Spacing #HAP-105-205-02 will need to be…

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…