Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
We do have a compatible grease seal for your 168255TC oil seal, however, we do not carry rubber coated seals in this size. The 168255TC oil seal was designed to work with oil bath hubs on a 3,500 lb axle. For the most part, axle manufacturers have…
view full answer...Over-Under kits are not designed for specific trailers. They are designed for specific axle sizes. Dexter Trailer Springs Over-Under Conversion Kit #K71-384-00 is for 2-3/8 inch axles Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 is…
view full answer...When selecting the correct replacement axle for a utility trailer you will need to know both the hub face (wheel center) and spring center measurements. For example, if your current hub face measurement is 88" and you replace this with an axle…
view full answer...Your answer really depends on how big the tires are you want to use. We generally recommend 2" between the tire and frame and 4" between the tire and fender for suspension. From here you would mock up your axle setup to see if your…
view full answer...There is a solution for you, but the lift kits you referred to such as #K71-725-02 will not work with welded on torsion axles. The best option is for you to simply remove your torsion axles and use the Timbren Axle-Less Trailer Suspension System…
view full answer...Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…
view full answer...There sure is; Titan is actually Dexter now, but there is a 6-hole weld-on bracket that you can use with the coupler. The exact parts you need are as follows: - Dexter Bolt-On Coupler for 2 5/16" Ball - Primed - 21K #T4855300 - Demco 6-Hole…
view full answer...I spoke with our contact at Tekonsha and he informed that the technical bulletin you are referring to is still valid. To install the Tekonsha Prodigy P3 into your 2012 Audi Q7, you will need to obtain a 12 volt normally open relay at a local Audi…
view full answer...The best installation instructions I can give you for installing the #C59236 on your 2015 Audi Q5 would be to use a circuit tester like part #PTW2993 to test the wiring harness of the taillights you have on your vehicle and then wire up the #C59236…
view full answer...Our contacts at Tekonsha said that you would apply that tech bulletin, linked for reference, when installing a brake controller such as the P3 #90195 on your 2015 Audi Q7. The parts needed from Audi may have different numbers than indicated in the…
view full answer...When installing a brake controller like the Tekonsha Prodigy P3 #90195 on your 2010 Audi Q5 you are correct that you do not want to connect the Red wire to the hot side of the brake light switch. You can find out if the pink or brown wire is the cold…
view full answer...There are a couple of factors that will determine if you are able to use a larger size tire and wheel on your trailer. First you will want to make sure that your trailer hub will accept a larger size wheel. Many of the trailer hub assemblies we offer…
view full answer...Filter Your Search
Contact and Help