Result: tail light mounting bracket

Since you have the Lippert Edge awning on your 2022 Coleman Lantern 17B, you'll need the following cover: Replacement Front Cover #LC32NJ Also just incase you find damage to the back cover, the replacement back cover is #LC43UD.

Due to the light weight of your trailer and boat I recommend looking at the Timbren Silent Ride Suspension for Single Axle Trailers. There are a few kits available based on the dimensions of your axle tube. This suspension is superior to leaf springs…

The hitch lock, part #S64029 that you came from for your Swagman Bike carrier should be pretty easy to remove. I have attached a photo of the lock and as the arrow indicates the hitch bolt has a threaded end. After you remove the lock end of the pin…

Your Gatormade axle will need these brakes. The Dexter Electric Trailer Brake Kit - 12-1/4" - LH/RH - 8K, part #DX32QR, will fit your Gatormade Aardvark. These brakes are rated for axles rated for 8,000 lbs. I have included a product description…

We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…

The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…

You could use a bracket such as #CE31005PG for bow stop #YRJONBLOCK. A lot of trailers use this type of bracket for bow stops. I have also included a link to all of the brackets we carry.

We only carry the Dexter Electric Trailer Brake Assemblies Left #DX25QR and Right #DX52QR for your Dexter axle. We do not carry the replacement lever, magnet or hardware separately for these brake assemblies.

You'd want to measure the width of your door opening/ramp and then go with the ramp spring that fits just to the inside of that. The part #ERS120D81 you mentioned is 81 inches wide.

When selecting ramp springs for a trailer ramp, you will want to know the diameter of your hinge pin and how much space you have available in the hinge. A typical horse trailer or utility trailer ramp uses 3/4 inch hinge pins and would require two…

The picture with the torn up bushing looks like the eye of your slipper spring. Is that correct? If so, it is coming undone and probably the reason you're having this problem. It should be enclosed and not look similar to the hook on the end of…

The Dexter Electric Trailer Brake Assembly #23-429 & #23-428 have a center opening of 3-7/8" for fitting on the axle tube. It will mount to bolt holes that are 3-5/8" spread left to right and 4-3/8" top to bottom. I have included…