Search: swing away trailer jack   >  

Based on everything you mentioned, the trailer jack I highly recommend for your trailer is the Round Snap Ring Swivel Jack with Footplate - Bolt On #TJBB-2001-B. This will easily bolt on to your 3" x 3" trailer tongue, has a 21-1/2"…

For your 3,000-pound compact John Deere tractor, I recommend the Gen-Y Hitch Aluminum Loading Ramp Set - 84" Long x 14" Wide - 6,000 lbs #325-GH-R84. Not only does this set provide you with 6,000 pound of maximum weight capacity, it also…

We sure can, but the Master Lock #605DAT lock you'd looked at isn't available keyed alike. We do have options for keyed alike coupler locks, however. I'd recommend a latch lock such as the etrailer brand #e98890 for a 7/8 inch span or…

Many of the lock products we offer can be ordered in multiples that are keyed alike and some of the Tow Ready brand locks are among these. The link at right will take you to our main page for locks that can be keyed alike, such as our coupler lock…

Thanks for sending in the pictures of your trailer. The Dutton-Lainson Pull Pin, Easy Swivel Trailer Jack, #DL22457, that you mentioned will fit a 2 inch by 2 inch frame but I think that I may have a better option for your trailer. Take a look at the…

While it is typically used as a bolt on jack the ARK Extreme Off-Road Swing-Up Trailer Jack w/ Dual Wheels part #ORJW750BD can be used as a weld on jack. The bracket that is used to mount it is a standard steel. You will have to clean off the finish…

It sure does! If you take a look at the accompanying photo I added from an install we did, you can see the Ark Off-Road jack installed on a C-channel trailer frame. The correct part number for this jack is the following: - Extreme Off-Road Swing-Up…

The Lippert Components RV Spare Tire Carrier with Winch - 71" Overall Width #LC159041 will use the Replacement Crank Handle for Lippert Components Manual Scissor Jack #LC285324. The Replacement Crank Extension for Lippert Components Spare Tire…

I have attached a few photos for you with all the dimensions we have for the Ark Drop Down Corner RV Stabilizer Jacks part #AR34FR. That said, Ark is an Australian company so the measurements are in metric, millimeter to be specific so you may need…

Here is an image I have from the Xtreme Off-Road Swing-Up Trailer Jack #ORJW750D in zinc which will have the same dimensions as the black Jack #ORJW750BD you are looking at.

As you can see by the accompanying photos, the Stallion Stabilizer Jacks #288-01892-2 are very similar to the Atwood 82298 jacks. They are drop leg jacks with 7 inches of drop leg travel, an extended height of 22-1/4 inches, a lift capacity of 650…

The drop leg on the Stallion Stabilizer Jacks #288-01892-2 that you referenced is held securely in place by a spring-loaded lever. The leg cannot physically drop unless the lever is pushed down by hand so you don't have to worry about a big bump…