Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The Dexter Electric Trailer Brake Kit #23-105-106 are a replacement set for the 023-358-00. This kit includes a right and left brake assembly that is manually adjustable. I recommend the Dexter Nev-R-Adjust Electric Trailer Brake Kit #23-458-459 as…
view full answer...Hey Al, so we have a solution but since disc brakes require a higher PSI than drum the #DM62VR would not work on drum brakes. Instead you'd want to go with the part #DM72VR which is basically the exact same thing but made for drum brakes. You can…
view full answer...The Kodiak Disc Brakes #KOD69FR will fit on 5,200lb axles which use the #42 spindle dimensions. This is the most commonly used size but depending on the age of your trailer you may want to inspect your spindle. It will have a grease seal landing…
view full answer...The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…
view full answer...Like you said, many factory integrated brake controllers will not work well with electric over hydraulic trailer braking systems. Some of the newer versions of these controllers now have an electric over hydraulic mode. Check to see if any of your…
view full answer...Replacement parts for an Atwood actuator are going to be very hard to find these days. Atwood stopped producing actuators quite a while back, so at this point unless you can find parts secondhand, replacing the actuator is going to be your best bet.…
view full answer...Yep, you got it, the bolt hole dimensions are 3" x 2-1/2" for the Dexter DX7.5L A-60 Brake Actuator For Disc Brakes #DX29FR. This fits over a 3" x 4" tongue and the ball to opposite end length you stated does not matter, no.
view full answer...If you're getting that much bounce out of your trailer that would lead me to believe that maybe the MORryde IS suspension system is the actual issue. Typically if the suspension is too stiff you'll start to bounce. We see this issue a lot…
view full answer...Sorry Richard, the best I can find is an image of the Inner Member #DX97FR for the Dexter DX7.5L A-60 Brake Actuator #DX33FR lower coupler mechanism spring.
view full answer...Yes, if you inserted a rod into the hole that in front of the housing of the actuator of the part #DM72VR that would work as a manual lock out and allow you to reverse the trailer.
view full answer...I do have some good replacement options for you although you'd have to drill a few new holes for mounting as none will line up with what you have now as the model is discontinued and there are no direct replacements. I recommend the Dexter DX7.5…
view full answer...Related Searches
Filter Your Search