Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Hey Richard, Thanks for the tag, I was able to determine you have the Regal design and would need the following components: Back Cover #LC643921 Drive Head Cover #LC643922 Idler Head Cover #LC643923 Replacement Manual-Override Grommet #LC95ED (not…
view full answer...Hello Larry, thanks for reaching out. We offer the Regal-Style Idler Head Covers in black #LC672052 and in white #LC672051. I am sorry to say that we do not offer them in brown. I do not recall ever seeing one in brown so they must not be as common.…
view full answer...If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…
view full answer...Since you were looking at the Regal style idler head #LC672052 I'm assuming you need to replace the idler head pin on your Solera awning. You can remove the old pin and install #LC27WD for a replacement. If by key you mean a cotter pin, then yes…
view full answer...So I just want to start with the brakes. Due to you having the 4,400LB Lippert axle you will need their Brake Kit #LC66WD for each axle. These brakes are forward self adjusting like the Dexter you were looking at. For a cushioned equalizer I prefer…
view full answer...Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…
view full answer...To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.
view full answer...The Regal Drive Head #LC53TF is a little skinnier and doesn't have a logo while the Plain Drive Head #LC273478 is a little wider and has the LCI logo on it (see attached).
view full answer...For the Lippert Solera Power Awnings 672050 you will want the Solera Power Awning Drive Head Black item #LC273478. This is the replacement drive head. The Solera Power Awning Idler Head item #LC672052 is the replacement idler head.
view full answer...In order to replace the light bulb part #67 inside of the Optronics Snap-In Mini License Plate Light part #LP11CB you will need to take a small screwdriver and then pry the light base away from the housing. I have attached a photo for where you will…
view full answer...Yes, to replace the bulb in the Optronics Snap-In License Plate light, #LP11CB, you will need to pry the bulb holder away from the lens housing with a small screwdriver. Rather than explaining it in detail, in writing, I produced a short video…
view full answer...In order to find the cause of the slippage issue you will need to disassemble and inspect the different components. The two most likely culprits are the motor and gear pack. If these are damaged we do offer replacements for them, the Replacement Gear…
view full answer...Related Searches
Filter Your Search
Contact and Help