Result: solar charge controllers

Hey Don, thanks for reaching out! The Furrion Chill Cube #FR99TD does have provisions built in to lower the amount of power required to start the unit up. I don't think Furrion officially calls it a soft start (there's debate about that…

Hey Gary, yes, we do have a base plate for your 2025 Ford Ranger! What you'll want is the Roadmaster Direct-Connect Base Plate Kit #RM23DQ. This base plate has removable arms, has hidden brackets for a non-obtrusive design, and has a simple…

Hey Paul; the answer to your question depends on what you want to do exactly. It also depends on what your trailer already has on it. I'm going to assume the 2016 Jayco Pinnacle you put in our fitguide is the trailer you have. I'm also going…

The fuse for the Go Power PWM Solar Charge Controller #GP76QR is not located on the controller itself. It should be inline on the wire running from the controllers positive port to the battery.

Yes, you can use the NOCO GEN On-Board Battery Charger #NOC34FR on your pickup's parallel batteries without disconnecting them. If your batteries were in a series, they would have to be disconnected. Since your batteries are parallel and maintain…

The positive terminal on your deep cycle battery will connect to the 12V circuit from your 2018 Ram 2500 to provide a maintenance charge and you do ground the battery from the negative terminal to your trailer frame. With that being said, the 12V…

Yes the Go Power Eco Solar Charging System part #34273836 that you referenced can be used to charge and maintain your 12 Volt battery on your trailer used for a winch. As you stated you use it sparingly and that is the key. If your were to use it…

The Replacement Converter Section for Progressive Dynamics 4000 Series RV Power Control Center part #PD4045CSV is a direct replacement for the converter section on the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger part…

The Go Power Lithium RV Battery #34282738 has a 100-amp hour capacity. You will need to compare this to the current flooded batteries you have installed to determine what increase in capacity will be. Whatever the increase in amp hours is will be the…

Since your space heater is rated for 1500 watt you would need a higher rated panel than the part #PD4060K which is only rated at 810 watts. The heater would over draw it. We do have the GO Power inverter part #34280055 which is rated at 2,000 watts…

The correct solar panels are going to depend on the amount of power your CPAP machine and appliances use, but based on some research I did, it looks like most of these machines are going to need in the neighborhood of 40 to 50 amp hours per night.…

Hi Robert, The amount of panels you can have is going to depend on their output and the maximum input capacity of the solar controller. For example, the Go Power MPPT Solar Charge Controller #GP54FR you were looking at has a maximum input of 1040W @…