Search: rear hanger   >  

Yes, you actually want to go with a leaf spring a bit shorter than what yours measure because they flatten out over time. So to replace your 25-5/8 inch leaf spring go with the 4-Leaf Double-Eye Spring for 5,000-lb Trailer Axles - 25-1/4"…

You can absolutely wire up a 3-wire breakaway switch like the Hopkins LED Breakaway Switch with 7" Lead Wires #HM20059 to replace your 2-wire switch; the difference is that the 3-wire switch has a dedicated ground wire while the 2-wire…

For your 28' enclosed trailer I recommend the Furrion Chill HE RV Air Conditioner System - Single Zone - 15,000 Btu - Black #FR23PV. If the ceiling of the trailer isn't too high and you can reach the air distribution box and don't want to…

The ST175/80-13 trailer tire size is approximately 3.6 inches taller than the tires you have now. Half of that is applied above the axle center line so there will be less than 1/2 an inch of clearance between the fender and the top of the tire. You…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

I went out to our warehouse and pulled a part #29-1 to get the internal dimension you asked for and found it to be 3 inches. This hanger is for use with 2 inch wide slipper springs. The Equalizer part #TREQ1344 is also for use with 2 inch wide…

Your current axle on your 4' X 6' Carry on Trailer will likely have either a BT8 Spindle #TRU59FR or BTR Spindle #TRU44FR. You can determine the spindle by removing your current hub and inspecting the bearings or by measuring the spindle…

Square axles can be tough to determine capacity. Often times the same spindle fits a range of axle capacities. The best way to determine the capacity is to get the inner and outer bearing numbers stamped into the metal of the bearings like you did.…

Nope, there is not any type of plastic wear bad to go between the 1-3/4" wide 3-Leaf Slipper Spring w/ Flat End for 2,900-lb Trailer Axles - 30" Long #e49SR and trailer frame.

The HITCH-LOCK Trailer Guard Coupler Lock by Dutton-Lainson #DL13980 is a great option for both keeping your trailer coupler locked in place and deterred from theft. You of course need an external padlock like the Master Lock Padlock #ML1KA for this…

Looks like you have slipper springs on your 2001 Coleman Utah pop up. We have replacement slipper springs available like the #e29SR which is 30 inches long and for 1,800 lb axles or the #SP-179275 which is 24-5/8 inches long and for 2,000 lb axles.…

Yes, the end of a slipper spring like the #e49SR will be very close to the hanger bolt in the unloaded position. There is no exact distance or placement, but it needs to allow for full suspension travel once installed. If the hanger is near the end…