Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
It sounds like the red wire in the wiring harness #C51352 was not in the correct place. Take a look at the picture I have included and make sure that the wires in your harness are in the same places. This is the end that plugs into the truck. It…
view full answer...To install a brake controller on your 2017 Chevrolet Silverado 1500 LT 4x4, you will just need the vehicle specific plug-in adapter. These adapters are usually brand specific. For example, if you go with the Tekonsha Prodigy P3 brake controller,…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...You will need the Dexter Electric Trailer Brake Kit w/ Parking Brakes #23-112-113 to replace the 12"x2" electric brakes on your trailer. This is a set which contains one set for the left and right side of your trailer. Since you are…
view full answer...For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.
view full answer...If you have never used a brake controller before, the P2 #90885 will be easier to learn on and use than the P3, #90195 initially. The P3 has several features the P2 doesn't including the ability to change the LED screen color, change the…
view full answer...I'd be pretty wary of using velcro or tape to install a brake controller. If it should come loose and fall without you noticing, the controller would not work correctly and could put you in danger. I've heard of folks that used 2 sided tape…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I have a solution for you but the Curt item #C69JR only has a 1,000 lbs tongue weight capacity. If your car hauler is loaded anywhere near its maximum capacity especially with that short tongue you will be way over 1,000 lbs. Instead I recommend the…
view full answer...I went ahead and confirmed with my contact at Curt that the spring bars on the Curt TruTrack 2P Weight Distribution System w/ Sway Control - 7-Hole Shank #C69JR are 35" from end to end. I went ahead and attached a diagram of this measurement for…
view full answer...When you are hardwiring a trailer brake controller like the Prodigy P2 #90885 the red wire connection that provides the triggering signal to the controller should be made to the wire on the COLD SIDE of the brake light switch circuit. This is the…
view full answer...The T-One Vehicle Wiring Harness with 7-Way Trailer Connector Item #118281 is the correct harness for your 2010 Nissan Pathfinder. The plug behind the passenger side kick panel can be difficult to locate because of the bundle of wires in that small…
view full answer...Related Searches
Filter Your Search
Contact and Help