Result: leaf spring lift kit

The MORryde AllTrek 4000 Equalizers for Tandem Axle Trailers #MR29DR are the new upgrade to their counterpart - the MORryde Premium Rubber Suspension Kit for Tandem Axle Trailers MR47ZR. According to MORryde, the AllTrek has been through more intense…

I checked with Dexter, manufacturer of many trailer parts, and according to them there should be at least 1 inch of space between the tires when under load. So once your trailer is loaded and ready to tow, if you have more than 1 inch of space…

When I researched Carlisle trailer tires ST235/80r16, the maximum PSI is 80. But read the following recommendations before filling to this PSI. To find the recommended PSI for your Ez-Loader trailer, there maybe a plate on the trailer frame near the…

On a towing setup you are always limited by the lowest rated component as the overall towing capacity since that is the weakest point. When it comes to trailer tires you always want to have them inflated to their max psi when cold. Not only do you…

Yes, radial trailer tires can spin in either direction. They are not directional. I attached an FAQ article on trailer tires for you to check out as well.

With your Take 3 trailer being over twenty years old the suspension could definitely use a tune up if you haven't already so new leaf springs are a good starting point. You'll want to ensure that you choose your leaf springs based on the…

The Torflex Lift Kit - Tandem Axle - 3-1/8" Lift #K71-725-02 is designed for a #12 Torflex Axle. What you have here is a spring axle. In order to lift your trailer I recommend the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00.…

The MORryde X-Factor Crossmember #MR99ZR that you bought was designed to fit the MORryde LRE, RE, or TRE leaf spring setups which if that's what you have it would work great with that. The other components, the lift kit part #LC407131 and #MR46ZR…

Yes, the Firman 10,000-Watt Portable Generator - 8,000 Running Watts - Propane or Gas - Electric Start Item #333-H08051 can be used in place of an alternate gen-set. You will need to ensure the two share the same connector. The Onan arrangement is…

According to the installation instructions from Dexter Axle the torque specs for the wet bolts on their Dexter E-Z Flex Suspension Kits, like part #K71-653-00, is 30 - 50 ft-lbs. I have attached a clip from their instructions for you to check out.

Thanks for sending a picture of your Ram! Yes, the Reese custom install kit #RP50054-58 you referenced with fit your 2014 Ram 2500 (6 or 8 foot bed) with rear coil suspension. I also attached the installation instructions for you too.

There is not an equalizer that will give you that height in the center. The #TREQ310 you already have are the tallest standard equalizer with the 4 inch center to center height. If you need to add 2 inches to your system, you will either need to…