Search: l11390   >  

Hey Bruce, thanks for reaching out! To replace the bronze bushings and wet bolts that fit the Road Armor Shock Absorbing Equalizer Kit #LC696740 you need the following: - Wet Bolt #MR52HR (Comes with 1) - Bronze Bushings Kit #K71-291-00 (Comes with…

For your 58 inch Lippert Edge RV awning the correct replacement idler arm is the part #LC62ED and the correct replacement drive arm (one with the motor) is the part #LC22ED.

I spoke with my contact at Fulton and he confirmed that both the Fulton XLT #F141133 and the F2 Swing-Up #F1413040134 will fit your trailer frame that measures 3 inches x 1-1/2 inches. Typically bracket height is measured from the bottom of the wheel…

The U-bolts of the U-Bolt Kit part #175211 are Grade 5. The torque specs for 9/16 diameter U-bolts like this is 65-95 ft lbs.

The Replacement U-Bolt for 2" Wide, Square Axles part #UBZC716X212X400 does not come with nuts. The bolts are 7/16"-14 so you can pick up nuts for them at any local hardware store. We do however offer a similar u-bolt in a kit which does…

I have a solution for you but we do not have a 2" square u bolt kit for a 3,500 lbs square axle that is 5 3/4" long. You will need to buy the u bolts and u bolt plates separately. The Square Trailer U-Bolt item #SP01-160 comes in a 2 pack,…

We sure do. U-Bolt Plate #117594-G is galvanized and attaches a 2 inch square axle to 1-3/4 inch wide leaf springs.

Redline U-Bolt #175211 is made from galvanized steel. The u-bolt is dipped into a hot zinc solution which helps it resist rust and corrosion. All such u-bolts, both round and square, appear on the linked page; all are made of steel with the same…

In order to pick out springs you need to remove the load on the trailer so that the leaf spring is not flattened out at all. You will want to measure from the center of the eye of the spring to the center of where the slipper spring contacts the…

The 4-Leaf Double-Eye Spring for 3,500-lb Trailer Axles - 27" Long #SP-210275 will work with your vintage trailer. It looks from the photo like you would also need the Replacement U-Bolt with Nuts for 2" Wide, Square Trailer Axles -…

I believe we have exactly the U-bolt you need. Check out the part #175211. This is a U-bolt designed for 2 inch square axles like you have that is 5-3/4 inches long on the inside of the U-bolt. I attached a picture that shows the dimensions. This…

The Easy Grease Trailer Idler Hub Assembly for 3.5K Axles #AKIHUB-545-35-G-EZ-K and the CE Smith Trailer Idler Hub Assembly w/ Case #CE13515 fit the same spindle, have the same bolt pattern, and are galvanized so yes, essentially the only things that…