Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
The difference between the Demco #DM62VR for disc brakes and the Demco #DM72VR for drum brakes is the pressure each one operates at so that why they cannot be interchanged. Disc brakes require 1600 PSI where drums like what your trailer has require…
view full answer...I do not have a wheel with these exact measurements. I do have tire and wheel combinations that are 10 inch diameter x 6 inch wide with a 5 on 4-1/2 bolt pattern. A link to selections available attached. The closest we have is the Kenda 205/65-10…
view full answer...The Dexter Zinc-Plated Brake Actuator w/ Lockout Shield #T47457107K that you referenced can be used with 2 or 4 brake assemblies.
view full answer...The brake assemblies that are on your 8k Dexter axles most would be the Dexter Electric Brake Assembly #23-435, the replacement brake magnets for this assembly would be the Replacement Magnet Kit #BP01-301.
view full answer...The Dexter DX Series #K71-651 and the Hydrastar Vented Marine #HS381-8067 are more comparable as they both have hardwire installations (just made by different manufacturers) while the Dexter BrakeRite II #T4813102 is more of a…
view full answer...Using a Brake Line Kit #DM5403 that uses all steel lines with the only exception being the rubber lines down to the axle so the suspension can travel will give you the most consistent braking for your trailer. The steel lines will not expand like the…
view full answer...That's a really good question, and there is a difference between the 7,500 lb Dexter DX7.5L A-60 actuators for disc brakes; the differences are both in what they fit, as well as their length. - 14" Long & Top-Mounted For 3" Wide…
view full answer...Here is what you will want to do. Since your 12 volt accessory circuit is only rated for 20 amps you are going to want to run a 10 gauge wire like the part #10-1-1 (sold by the foot) from the positive battery post of your vehicle through a 40 amp…
view full answer...You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…
view full answer...For your Kodiak Disc Brakes, part #K2HR858D, you do in fact need a hydraulic actuator and lines. The HydraStar Vented Marine Electric Over Hydraulic Actuator, part #HS381-8067, is a decent choice. However, I recommend part #HBA16-252-82 instead as…
view full answer...For the absolutely best performance and reliability you can't beat the HydraStar electric over hydraulic actuators. We have found that they are the most reliable, react the fastest and just in general work the best. For just the actuator you…
view full answer...Filter Your Search