Search: jacks and jack stands   >  

The Round A-Frame Trailer Jack #TJA-5000S-B has mounting holes that are elongated. The actual holes are 3/4 inch long and 7/16 inch wide. That gives you a minimum of 2-1/2 inches or maximum of 3-3/4 inches to the nearest or farthest part for…

I cannot know for certain but I can say that generally, the black wire is for 12 volt power, the white wire is for ground, the yellow wire is for left turn/brake, the green wire is for right turn/brake, and the brown wire is for running lights. This…

To add a 100 lb tank to your two tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the pigtail…

You can measure either the outer diameter of the part of the dust cap that fits into the hub OR the inner diameter of the hub where the dust cap goes using calipers such as #PTW80157. Calipers are needed because the measurement has to be as accurate…

We do have the Curt multi fit hitch part #C13704 that has a 5,000 lb towing capacity and can fit RV frames that are between 22 and 66 inches apart. You'd have to make sure your frame dimensions are compatible and that your trailer when loaded…

The Roadmaster Spare Tire Carrier #RM-195125 is going to likely be your best option. The only other option would be a Carrier #e98ZR you would have to remove to open the door. I have added an image with the length of the carrier below as you may…

Thank you for all of the info! You can safely use a wider tire, but we recommend having 3" - 4" of clearance from the tire to the wheelwell (fender) so that they don't make contact when your suspension moves. I'm not sure what size…

Although the equalizers included with the Dexter #K71-359-00 Heavy Duty Suspension are a 1/2 inch taller and a 1/4 inch different in width than the original equalizers, that difference isn't enough to affect the fit. The trailer height will be…

If you used the Dexter Equalizer kit part #K71-359-00 that you referenced the distance between the axles would be 33 inches.

The Wesbar 271594 is a sealed light which means the lens is not replaceable. The only solution is to replace the entire light. The parent company for Wesbar recently changed, so as of May 2023 this particular light is on indefinite backorder. I…

To get a metal vent cover roof vent on your trailer you would have to replace what you have on your trailer with the part #V2110SP-24 like you mentioned. It does attach by using screws that attach through the outside like what you see in the picture…

I did not see where you mentioned what electric over hydraulic actuator you are using but if it is the HydraStar Marine Electric Over Hydraulic Actuator part #HBA16 that you referenced then the first thing I recommend you check is that you are using…