Search: idler head cover   >   Accessories and Parts   >  

Hey Jim! The Replacement Back Cover for Solera Power Awnings - Drive Head or Idler Head - Regal Style - Black #LC643921 is a pretty simple installation that just requires you to remove the mounting screws, remove the cover, and then reverse the…

To replace the screws on the Front Cover for Solera Power RV Awnings item #LC643922 you will want the Replacement Solera Manual Awning Head Cover Fastener item #LC266156. These are #6 pan head screws that are a 1/2" in diameter. We do not…

Yes, the Replacement Rear Cover for Solera Awnings in Black with the new Regal style is part #LC643921. This is the correct rear cover for both the drive and idler sides whether you have the Regal style with the speakers or not.

Thanks for the information. I checked with Lippert and didn't get anything back on the first two numbers and the last one is a fire safety code. The good thing is there aren't many options for replacement motor covers for Solera awnings. I…

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

Based on the pictures you definitely need the awning support arm #LC281154. I can't tell in that other photo if the pin is bent or damaged, or just barely hanging in there. I'm also not sure if your idler head and roller endcap are ok or not…

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…