Search: idler head cover   >  

Hey Jim! The Replacement Back Cover for Solera Power Awnings - Drive Head or Idler Head - Regal Style - Black #LC643921 is a pretty simple installation that just requires you to remove the mounting screws, remove the cover, and then reverse the order…

Thanks for the information. I checked with Lippert and didn't get anything back on the first two numbers and the last one is a fire safety code. The good thing is there aren't many options for replacement motor covers for Solera awnings. I…

To replace the screws on the Front Cover for Solera Power RV Awnings item #LC643922 you will want the Replacement Solera Manual Awning Head Cover Fastener item #LC266156. These are #6 pan head screws that are a 1/2" in diameter. We do not carry…

Yes, the Replacement Rear Cover for Solera Awnings in Black with the new Regal style is part #LC643921. This is the correct rear cover for both the drive and idler sides whether you have the Regal style with the speakers or not.

Based on the pictures you definitely need the awning support arm #LC281154. I can't tell in that other photo if the pin is bent or damaged, or just barely hanging in there. I'm also not sure if your idler head and roller endcap are ok or not…

If you are referring to the head pin then yes we do have this available as the Replacement Head Pin for Solera Power Awning Gear Drive Head part #LC266141. That said, you would also want two Replacement Retaining Clips part #LC266137 and one…

Not quite, there is an additional screw below the wax screw in the end cap that also must be removed on the Solera Power Awning Idler Head #LC672052. From here you can remove the roll tube from the drive head. After the drive head is removed, there…

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Meg, for your Lippert Solera 2000 series awning you can use the Replacement Front Cover for Lippert Edge Awnings #LC32NJ for the front and #LC43UD for the rear to replace your damaged cover. Also, if by cap you're meaning the manual override…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Thank you for the photos! It looks like you have the Regal Style awning head so for a replacement front cover you need part #LC643923 for the idler side. If there is a clip missing on the back cover then I recommend replacing that as well so the…