Result: hm56200

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

On the Jeep Wrangler and Jeep Truck models the steering wheel does not actually lock with the ignition in the off position, it just has a loss of power steering-which is likely what you're experiencing. Jeep removed the steering wheel lock from…

If you are using a Maximus 3 base plate with a Blue Ox tow bar that would mean that you have a Blue Ox tow bar adapter currently and the correct Roadmaster Nighthawk tow bar setup would be the one set up for Blue Ox base plate kits part #RM-677.

I think what you are looking for is the RoadMaster BreakAway kit, part #RM-98160. This kit was originally designed to be used for a second vehicle so all you have to do is move the cylinder and brackets. Since you have the bracket and cylinder, and…

The correct way to wire up the breaker that comes with the Roadmaster charge line kit part #RM-156-25 is to have the copper post ran to the positive post of the battery that is charging the other vehicle and the silver side to the battery that is…

The Reese 74950 Tow Champ is not designed for the purpose of welding it to the front of a trailer to create a trailer tongue. If you are looking for parts to custom fabricate an item then I suppose you can start with something such as this, but that…

If the 2018 Jeep JL Wrangler has a factory tow package you can just use a Tekonsha Brake Controller p3 part #90195 with a brake controller harness part #3073-P to install a brake controller in the Jeep. The harness will plug into a port under the…

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…

I may have a solution for you but I'm not aware of a bolt on safety chain bracket or clevis that can be used. However you can simply take a safety chain set (or your existing chains) like the 42" Long Safety Chain with 3/8" Clevis Hook…

The BrakeBuddy Towed Vehicle Battery Charge Kit part #BB54FR comes with a the Brake Buddy Select 3 Portable Supplemental Braking System part #HM39524. I have attached a wiring diagram of how this is setup with the Brake Buddy.

I do have a better option for you but the Tekonsha Two Stage 12 V DC Battery Charger part #2024-07 is mainly used to charge a breakaway systems battery which is much smaller than the 12 volt battery you have on your toad. A better option for you…

If all you want is to prevent the 12 volt power supply of your trailer battery wiring from backfeeding onto your vehicle wiring or vice versa what you need is a one-way diode like part #RM-690. This only allows current to flow in one direction so…