Result: fstc1000301

Since your trailer's torsion axle is rated for 3500-lbs, and since a 4 x 8-foot trailer frame is unlikely to weigh more than a few hundred pounds, you should still be well within the axle capacity even when you have 2500-lbs of firewood loaded.…

We have one 14" wheel available with a 4 bolt pattern. That is the Dexstar Vintage Steel Wheel w/ +5 mm Offset #AM20312. The rim dimensions are 14" diameter x 5-1/2" wide and it has a 4 on 9.44 bolt pattern. These have a silver powder…

The TDE 46245 you have is a Hub and Rotor for a 3500lb axle and uses inner bearing #L68149 and outer bearing #L44649 and uses the 5 on 4-1/2" bolt pattern For a replacement idler hub you can use the Trailer Idler Hub Assembly for 3,500-lb E-Z…

If it is a 1000 psi then it would be the Hydrastar for drum brakes. The newest one is #HBA-10 and it has different wire colors, see picture. So you know that black is 12 volt power in and white is the ground. Blue/white goes to the break away switch.…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I have a solution for you. We do not have those exact dimensions however the Better Bath RV Shower Pan - Front Drain - 32-1/8" Long x 24" Wide - White #LC210367 and the Better Bath RV Shower Pan - Front Drain - 27" Long x 27" Wide…

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

We have a rubber key hole cover for the Bauer Cam Latch #BA32FR with the part #BA49VR. It does not come with this cover.

I may have a solution for you, but we don't have anything that matches your AL-Ko MD285 jack. You could likely make the Dutton Lainson #DL22530 jack you were looking at work, and you'd just need to add the caster #DL22414. This Dutton Lainson…

We do have what you need to replace the UFP HD-1377-10 hub and drum as well as add hydraulic brakes for your boat trailer. Here are the exact parts you will need: - Dexter Trailer Hub and Drum Assembly #84546UC3 - Hydraulic Trailer Brake Kit -…

For your trailer axle, the Electric Trailer Brake Kit - Self-Adjusting - 10" - Left and Right Hand Assemblies - 3,500 lbs #AKEBRK-35-SA are a great choice. After the initial adjustment at installation, they will self-adjust to maintain proper…

Thank you for the measurements you provided and for the photo of your trailer suspension mockup showing the spring components' spacing. As long as your shackles do not hit the trailer frame (you mention 1/8-inch clearance) you should be fine, but…