Videos
for Search Results
Help Articles
for Search Results
Expert Answers
for Search Results
Since your entry height is 34 inches and your current stops are 27.5 inches wide you'd want the Torklift GlowStep part #TLA8004. Even if you could get away with the three step version it would be easier to climb up the four steps since they…
view full answer...The Yakima Replacement Anchor Plate Style-A, Part #Y8810074, comes as a set of 8 plates that measure 3/4-inch x 7/8-inch. The centered threaded hole measures 0.2 inches (or 5.1 millimeters) in diameter. Please refer to the photo provided. The…
view full answer...The Lend-a-Hand Extra Large Folding Grab Handle #AM-533 does not have a specific weight capacity. According to Stromberg Carlson, this is only to assist and not weight bearing. Typically this is installed by driving the screws into a stud so it…
view full answer...The Manual Pull Out Steps part #SMFP-2100 that you mentioned are going to fit your 2011 Palomino Puma 27KFQ only when you use the Lippert Outriggers for Manual RV Steps #LC301704. If you need a smaller step you can use #SMFP-2120 instead. The…
view full answer...I recommend the NOCO Commercial Grade battery box part #329-HM484 to hold both of the group 24 batteries. From my research a group 24- 12 volt battery measures 10.25" long x 6.8125" wide x 8.875" tall. This battery box measures…
view full answer...Yes, the Replacement Anchor Plate "A" for Yakima Landing Pad 1 #Y8810074 will fit the Yakima rails on your A.R.E. truck bed camper. Please note that these are meant to be used with the Yakima Landing Pad 1 feet so it may not fit your…
view full answer...The anchor plates that fit into Yakima roof tracks are the part #Y8810074 which is 3/4 inches wide. This is the same width as the anchor bolts of the #Y01162 which is designed to fit Yakima crossbar top channels. So the #Y01162 would work well…
view full answer...The Brophy Camper Scissor Steps - 4 Steps in aluminum, #AS04 has a shipping weight of 21 lbs. The Brophy Camper Scissor Steps - 4 Steps - Steel, #SS04 is 34 lbs.
view full answer...For your 2016 Rockwood Forest River Freedom 1950 Pop-Up Camper, I recommend looking at the Flexco Manual Pull-Out Steps #SMFP-2120. This 2-step unit features 20 inch wide steps with a non-slip surface and a 1-1/2 inch wide strip of grip tape on the…
view full answer...Email me the picture you have and I'll take a look!
view full answer...Yes, you can use the Flint Hill Goods Hitch Mounted Aluminum Cargo Carrier #FHG59ZR with your front mount hitch on your 2011 GMC Sierra. There will be a few things you should be aware of though. A loaded cargo carrier can reduce driver visibility,…
view full answer...My contact at Dexter Axle tells me that when installing a brake assembly to the backing plate of a 3500 lb axle, the bolts should be tightened in a criss-cross pattern to between 45-70 foot lbs.
view full answer...Filter Your Search
Contact and Help