The Thule Hullavator Pro Kayak Roof Rack #TH898 will either clamp around the Thule WingBar Evo Crossbars #TH711420 or can be held inside the channel. The Bar Mount Assembly #7521741001 included with the carrier allows for either style attachment to…
I attached a chart that has the automotive cross reference for the Kodiak disc brake pads part #K2250CP that you referenced under the yellow heading. Probably the easiest to look up would be 1982 to 1992 Chevy Cavalier.
We do not have a Kodiak disc brake caliper cross reference to automotive calipers but for the brake pads there are cross referenced parts. If you refer to the linked image you'll see a partial list of cross-compatibility of brake shoes for GM…
I would check the magnets for wear before going on to test them with a meter. If the magnets show abnormal wear or if you can see the windings beginning to show through the friction surface of the magnet then they will need to be replaced. To further…
The #BP19-001 retaining clips are designed to fit the Dexter 7-inch brake magnets. Our contact at Dexter said the BP19-001 will work on both the 7-inch round and the 10-inch oval magnets. The replacement magnet clip, part #BP19005 will fit 10, 12,…
Thanks for the picture! Yes, the BOLT Trailer Hitch Receiver Lock - 2", 2-1/2", and 3" Hitches - Ford Side-Cut Key item #BL7023585 will work with your key fob. This system is confirmed to fit your 2019 Ford F-250 Super Duty's key.…
Normally we use channel locks for spindle nuts. But the Nev-R-Lube hubs are a different animal. You will need a 1-7/16 inch 6 or 12 point socket for a Nev-R-Lube nut #6-183. When you are ready to reinstall it you will need a torque wrench capable of…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Hey Mark, I spoke with Thule and found that the Pro bar mount assembly #7521741001 would not be a fit, but we do still offer the original Hullavator bar mount assembly with part #TH753352403.
While it is possible to replace just the magnet like part #Replacement Magnet Kit for 12" Electric Trailer Brake Assemblies part #AKBRKR-M12 I highly recommend replacing the entire assembly. It proves very cost effective and can save you labor…
If you wanted a to put a second mounting bar of a Thule Hullavator part #TH898 you'd need the bar part #7521741001 that you referenced as well as the hardware bag part #TH88JV as well.
The Yakima HD Crossbars #Y01156 will work with the Thule Hullavator #TH898. Based on the pictures you sent in it looks like you have the crossbars installed upside down. The end caps have an opening on the other side that lets you easily slide in…
Filter Results
