Search: e67sr   >  

The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…

I checked with CE Smith and you will want to torque the 1/2" bolts of the U-Bolt Kit item #CE23003 to 65 ft lbs.

Typically the hub would be dropped into the rim from the rear until it seats on the lip that runs around the inside of the rim. The rim clamps would then be put in place, and evenly tightened to secure the hub to the rim. If the hub is not seated…

The torque for the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles - 12" - 5 Spoke Utility #8-174-5UC3 is not specified by the manufacturer. For 9/16 inch studs, the typical lug nut torque will be 120-140 ft lbs based on most…

It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…

It sounds like you are heading in the right direction. To decide where your springs seat will be you will need to mock up your trailer as if you were installing all of the equipment on it. Once you have the suspension part mocked up you will want to…

The Bargman 7-Way, RV-Style Connector #WG54006-043 referenced in your question uses the standard RV-style pin locations for its 7-Way connector. I have attached a diagram of these locations and their functions for you to check out. Wire colors will…

The Tru Ryde grease seals you mentioned, part #RG06-70 are indeed a replacement for the 10-036-00 Dexter seals. They would work great for your application.

It sounds like you have an equalizer bolt like part #7-136-2-6-112 as opposed to one with a hex head like the part #7-169-6-112. This is fine as long as the diameter and length matches what you're needing. When installing suspension bolts on your…

The correct replacement leaf spring bushings for any given trailer will be dependent on the width and type of the leaf springs. The most common for a Dexter 10,000 lb Trailer Axle are 3" wide slipper springs. If you have 3" wide slipper…

We have the 3/4" Conical Washer #3232 and 3/4" Bolt #090747 that is 4-1/2" long. There is also the 3/4" Nut #F2135823295 with the same 16 threads per inch as the bolt.

Thanks for that info! Your model number 8333-8664 air conditioner is a Coleman-Mach and we do have the correct replacement shroud for you: - MaxxAir Replacement RV Air Conditioner Cover - Coleman-Mach / RVP Brand #MA8335A5261 The cost can be found on…