Search: drop hitch ball mounts   >  

I have a solution for you, and while most Fastway products are made in the U.S.A. it looks like the steel #FA49-00-5925 was not. Instead, I recommend using the aluminum Flash E Series HD Adjustable 2-Ball Mount #FA42-00-2925 which has a similar…

I have a great solution for you. Check out the Shocker Hitch XRC Cushioned Ball Mount for 2-1/2 inch hitches part #SHK94RR. This gives you 7-1/2" drop, so a little less than the Fastway kit, but since it does not carry the extra ball below…

I have a solution for your ball mount needs; I recommend the Flash Strong Solid Steel 2-Ball Mount - 2.5" Hitch - 10" Drop, 9" Rise - 20K #FA49-00-5925. The 2-5/16" hitch ball on this has a 20k capacity which is the most of any…

Yes, the wheel of a motorcycle or bicycle can rest on an e-track no problem.

The Fastway Flash E Series HD Adjustable Ball Mount #FA42-00-2925 referenced in your question has a distance of 16 inches from the top of the shank to the bottom of the unused hitch ball when set at its lowest position. This will certainly provide…

The manufacturer does not provide a weight rating for the Erickson E-Chock Wheel Chock for E-Track, #EM09162. These are designed with overall dimensions of 8-1/2" long x 6-3/8" wide x 4-1/2" tall and to be used with a tie-down strap.…

For your 2022 Chevrolet Silverado 2500HD with the Multi-Flex tailgate B&W has a line of hitches that were specifically designed for your tail gate in mind. B&W Tow & Stow 2-Ball Mount #BWTS20066BMP B&W Tow & Stow 2-Ball Mount…

The Flash Solid Steel HD Adjustable 2-Ball Mount #FA49-00-5925 does have a bit of side-to-side play against the drop-bar, and this is typical of all two-piece adjustable ball mounts. How much play depends on the manufacturer, but typically it is…

The Curt 7-Way RV-Style Trailer Connector - Vehicle End #C58155 will connect to the Hopkins 7-Way RV Style Connector with Molded Cable #H20046 to make an extension with the following pin to color combinations because Hopkins uses odd colors. White to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

The Curt Weight Distribution Shank part #C17132 offers up to 9-1/4" of drop. In order to see if this is enough for your truck/trailer combo you will need to take some measurements. If the distance from the ground to the top inside edge of the…