Search: dexter vault   >  

Thanks for the pictures! Since your UFP Gold Series oil bath hubs have a 1.98" outer bore then yes, the Kodiak XL ProLube Oil Bath Hub Body and Cap item #xlprolube1980 would work for your boat trailer. The directions say to fill to…

We have just what you need based on the dimensions you listed. The correct grease seal you need is the part #168255TB which has outer diameter of 2.561 and an inner diameter of 1.687 inch.

The Optronics LED Trailer Tail Light, Item #STL211RB, is only one light and not a pair. I have attached a video for you to check out.

We don't have the UFP Brand, but I can give you some compatible parts. For your trailer hubs with rotor, I recommend the Kodiak 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Dacromet - 3,500 lbs #KHR10D. You will need grease seal #RG06-050 along…

According to Dexter, this is a 3,750 lb torsion axle with a 90.3" hub face measurement. More than likely your axle uses #L68149 and #L44649 bearings with a #168255TB grease seal. You will need to verify this information since Dexter did not have…

I do have an option for you but we don't offer any direct bolt-on swap options for the Tie Down Engineering LP7000 Actuator due to the age. That said, we do have plenty of great replacement options like the Dexter DX7.5L A-60 Brake Actuator part…

I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…

You'll basically just need to remove as much of the oil from your hubs as you can and then pack them with grease instead of oil. Oil seals and caps seal better than grease seals and caps so to make the conversion you want to make is not hard at…

Sounds like you have a blown grease seal on your trailer. This is a pretty common problem. To pick out a replacement grease seal you will need to measure the diameter of the spindle where the grease seal rides with a digital or dial caliper and then…

Hi Danny, Evangeline asked if I could get you helped out as she is climbing around the roof of an RV at the moment and couldn't get to a computer, so here I am. Let's get into it. Since you have a 3,500 pound axle with Dexter's Vault…

Yes, the Curt hitch part #C77ZV is a fit for the 2023 Toyota Crown Hybrid. I attached a link to the install instructions as well as a link to an installer finder in case you wanted to find someone near you to install the hitch.

Hello Ray, thanks for reaching out. The #GS-2250DL are for grease only, and they are not intended to be used in an oil bath system. A better option for that is the Timken Grease Seal part #TMK98ZR. This is identical in size to the #GS-2250DL seal,…